Installation Instructions

FormNo.3441-209RevB

TX427andTX525SnowThrowerPowerKit

CompactToolCarrier

ModelNo.144-2512

InstallationInstructions

Installation

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Lowertheloaderarms.

3.Shutofftheengineandremovethekey.

4.Openthehoodandsecureitwiththeproprod.

RemovingtheFusePanel

TX525Only

1.Pullthehairpincotterfromthebottomendofthe

hoodprop-rodandslidetheproprodoutofthe

retainingbracketsandtheprop-rodtab.

g004984

Figure1

1.Prop-rodtab4.Retaining

bracket—bottom

2.Retainingbracket—top5.Hairpincotter

3.Proprod

2.Removethe4screwssecuringthefusepanel

andthenpullthepaneloutanduptoremoveit.

g004985

Figure2

1.Fusepanel

2.Screw

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3441-209*

PAGE 1
Form No. 3441-209 Rev B TX 427 and TX 525 Snow Thrower Power Kit Compact Tool Carrier Model No. 144-2512 Installation Instructions Installation 2. Remove the 4 screws securing the fuse panel and then pull the panel out and up to remove it. Preparing the Machine 1. Park the machine on a level surface. 2. Lower the loader arms. 3. Shut off the engine and remove the key. 4. Open the hood and secure it with the prop rod. Removing the Fuse Panel g004985 TX 525 Only 1.
PAGE 2
Installing the 12 V Receptacle WARNING Using a drill without proper eye protection may allow debris to enter the eye, causing injury. When drilling or carrying out other operation, always wear eye protection. 1. Mark and drill a hole (1-5/32 inch diameter) into the control in the location shown in Figure 3 or Figure 4. Note: If you do not have a 1-5/32 inch drill bit, use a 1-1/8 inch drill bit to drill the hole and then grind the hole to expand it. g331119 Figure 3 TX 427 g331151 Figure 4 TX 525 2.
PAGE 3
Installing the Wire Harnesses g333594 Figure 6 1. Wire harness installed on TX 427 1. 2. Wire harness installed on TX 525 Install the post connectors from the port wire harness to the posts on the 12 V receptacle. g331130 Figure 8 g311406 1. Port wire harness 3. Splitter harness 2. Outgoing power connectors 4. Accessory connector of machine wire harness Figure 7 1. Negative (-) connector 3. Positive (+) connector 2. Negative (-) post 4. Positive (-) post 2. 3.
PAGE 4