Installation Instructions

FormNo.3431-175RevA

PivotPinKit

TXL2000ToolCarrier

ModelNo.139-5732

InstallationInstructions

Installation

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Lowertheloaderarms.

3.Removeanyattachments;refertotheOperator’s

Manualforthemachine.

4.Shutofftheengineandremovethekey.

RemovingtheExisting

PivotPin

1.Oneachsideoftheattachmentmountplate,

removethebolt(5/16x2-1/2inches),locknut

(5/16inch),andlinkpinsecuringthehydraulic

cylinderrodtothemountplate(Figure1).

g283507

Figure1

1.Bolt(5/16x2-1/2inches)3.Locknut(5/16inch)

2.Hydrauliccylinderrod4.Linkpin

2.Rotatetheattachmentmountplateforwardso

thatitisrestingontheground(Figure2).

g283509

Figure2

3.On1sideofthemountplate,loosenthebolt

(1/2x3-1/4inch)securingthepivotpinsothat

theheadoftheboltisatleast6mm(1/4inch)

outfromtheoriginalposition(Figure3).

g283506

Figure3

1.Loosenthisbolt.

4.Useahammertostriketheheadofthebolt

topushthepivotpintowardthemiddleofthe

machine.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3431-175*A

PAGE 1
Form No. 3431-175 Rev A Pivot Pin Kit TXL 2000 Tool Carrier Model No. 139-5732 Installation Instructions Installation 2. Rotate the attachment mount plate forward so that it is resting on the ground (Figure 2). Preparing the Machine 1. Park the machine on a level surface. 2. Lower the loader arms. 3. Remove any attachments; refer to the Operator’s Manual for the machine. 4. Shut off the engine and remove the key. Removing the Existing Pivot Pin 1.
PAGE 2
5. Installing the New Pivot Pins When the pivot pin is removable, remove the bolt, washer, and pivot pin (Figure 4). 1. 2. 3. Install the grease fittings onto the new pins. Align the holes in the loader arms with the holes in the attachment mount plate. On both sides of the attachment mount plate, slide the tapered end of the pivot pin into the holes from the inside of the attachment mount plate. g283508 Figure 4 1. Bolt (1/2 x 3-1/4 inch) 3. Pivot pin 2. Washer 6.
PAGE 3
7. Insert the hydraulic cylinder rods into the attachment mount plate and secure them with the link pins, bolts (5/16 x 2-1/2 inches), and locknuts (5/16 inch) removed previously (Figure 7). Torque the locknuts to 20 to 25 N∙m (15 to 18 ft-lb). g283507 Figure 7 1. Bolt (5/16 x 2-1/2 inches) 3. Locknut (5/16 inch) 2. Hydraulic cylinder rod 4. Link pin 8. Grease the base and rod end of the hydraulic cylinders and the pivot pins. 9.
PAGE 4