Installation Instructions

ManualsBrandsToro ManualsCompact Utility LoadersDipstick Kit, TXL 2000 Tool Carrier

FormNo.3431-601RevA

DipstickKit

TXL2000ToolCarrier

ModelNo.139-4845

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Nopartsrequired

–

Removetheenginepanel.

Dipstickguide1

Dipstick1

Bolt(M8x12mm)

Cabletie

Installthenewdipstick.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Removeanyattachments;refertotheOperator’s

Manualforthemachine.

3.Raisetheloaderarmsandsecurethemwith

cylinderlocks.

4.Shutofftheengineandremovethekey.

RemovingtheEnginePanel

Note:Reversetheproceduretoinstalltheengine

panelafterinstallingthekit.

1.Openthehood.

2.Removethescrewclampsecuringthehoseto

thehydraulic-tankbreatherontherightsideof

theenginepanel(Figure1).

g286600

Figure1

1.Hydraulic-tankbreather3.Hose

2.Screwclamp

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3431-601*A

Summary of content (4 pages)

PAGE 1
Form No. 3431-601 Rev A Dipstick Kit TXL 2000 Tool Carrier Model No. 139-4845 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. No parts required – Remove the engine panel. Dipstick guide Dipstick Bolt (M8 x 12mm) Cable tie 1 1 1 1 Install the new dipstick. Preparing the Machine Removing the Engine Panel 1. Park the machine on a level surface.
PAGE 2
Installing the New Dipstick 3. Remove the hose from the breather. 4. On the left side of the engine panel, remove the 2 bolts (5/16 inch) and 2 nuts (5/16 inch) securing the left grille plate to the engine panel (Figure 2). Note: The existing dipstick and guide does not need to be removed. 1. Remove the plug on the left side of the engine (Figure 3). g286599 Figure 2 g286748 1. Engine panel 4. Bolt—5/16 inch (2) 2. Nut—5/16 inch (2) 5. Bolt—3/8 inch (2) 3. Left grille plate 6.
PAGE 3
g286747 Figure 4 1. Dipstick 3. Bolt 2. Dipstick guide 4. Secure the dipstick guide bracket using the bolt (M8 x 12mm) in the cable-tie hole (Figure 4). 5. Secure the wire harness to the bracket using a cable tie (Figure 5). g286746 Figure 5 1. Cable tie 6. Install the engine panel; refer to Removing the Engine Panel (page 1). 7. Close the hood.
PAGE 4