Installation Instructions

FormNo.3430-985RevB

AuxiliaryWireHarnessKit

TXL2000ToolCarrier

ModelNo.139-1186

ModelNo.139-1188

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Wireharness1

Lockwasher1

Connectornut

Couplingcover

Cabletie(telescopingmodelsonly)

Installthewireharness.

Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.Lowertheloaderarms.

3.Shutofftheengineandremovethekey.

4.Opentherear-accesscover.

5.Turnthebattery-disconnectswitchtotheOFF

position(Figure1).

g261512

Figure1

1.Battery-disconnect

switch—OFFposition

2.Battery-disconnect

switch—ONposition

8111LyndaleAvenueSouth

Bloomington,MN55420Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3430-985*

PAGE 1
Form No. 3430-985 Rev B Auxiliary Wire Harness Kit TXL 2000 Tool Carrier Model No. 139-1186 Model No. 139-1188 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine. 2 Wire harness Lock washer Connector nut Coupling cover Cable tie (telescoping models only) 1 1 1 1 1 Install the wire harness.
PAGE 2
. 2 Plug the rocker switch connector from the auxiliary wire harness to the accessory rocker switch connector (P91) on the machine wire harness, near the joystick connector. Installing the Wire Harness Parts needed for this procedure: 1 Wire harness 1 Lock washer 1 Connector nut 1 Coupling cover 1 Cable tie (telescoping models only) Procedure 1.
PAGE 3
4. Continue routing the wire harness down the loader arm (Figure 5 or Figure 6). Note: For telescoping models, remove the cross bars on the hose carrier to route the wire harness along the hoses, then install the cross bars. g338626 Figure 7 Hose fittings not shown for clarity 1. Coupling cover 3. Lock washer 2. Connector nut 4. Connector g282760 Figure 5 Telescoping model 6. For telescoping models, secure the wire harness to the hydraulic hose fittings using a cable tie.
PAGE 4