Installation Instructions

FormNo.3424-755RevA

RotarySensorCoverKit

2024or2226DirectionalDrill

ModelNo.138-7092

InstallationInstructions

InstallingtheKit

1x1x1x2x2x1x

1x1x1x1x

1.Parkthemachineonalevelsurface,placethethrustframeinthehorizontalposition,shutofftheengine,

turnthebatterydisconnectswitchtotheOFFpositionandremovethekey.

2.Locatethecamassemblywhereyouwillinstallthekit(Figure1).

g260428

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3424-755*A

PAGE 1
Form No. 3424-755 Rev A Rotary Sensor Cover Kit 2024 or 2226 Directional Drill Model No. 138-7092 Installation Instructions Installing the Kit 1x 1x 1x 1x 1x 2x 2x 1x 1x 1x 1. Park the machine on a level surface, place the thrust frame in the horizontal position, shut off the engine, turn the battery disconnect switch to the OFF position and remove the key. 2. Locate the cam assembly where you will install the kit (Figure 1).
PAGE 2
3. Disconnect the sensor wires and remove the cable tie attached to the bracket (Box A). 4. Place the wire harness cover on the sensor wire harness (Box A). g261455 5. Install the bracket onto the machine as shown in box B. 6. Determine which slot on the bracket the sensor wire harness will fit through without stretching the harness. 7. Install the cable tie connector into the hole closest to that slot (Box C). 8.