Installation Instructions

ManualsBrandsToro ManualsMisc.PTO Switch Kit

FormNo.3419-349RevA

PTOSwitchKit

ModelNo.138-1911

InstallationInstructions

Introduction

Important:ThetermPTOswitchistheequivalenttocuttingunitengagementswitch.

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCalifornia

tocausecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

PreparetoinstallthePTOswitchkit.

Nopartsrequired

–

Removethe5-socketconnector.

Nopartsrequired

–

RemovethePTOswitch.

Adapterwireharness1

PTOSwitch

Installtheadapterwireharness.

Nopartsrequired

–

Connectthebattery.

Nopartsrequired

–

TestthePTOSwitch

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3419-349*A

Summary of content (8 pages)

PAGE 1
Form No. 3419-349 Rev A PTO Switch Kit Model No. 138-1911 Installation Instructions Introduction Important: The term PTO switch is the equivalent to cutting unit engagement switch. WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
Preparing to Install the PTO Removing the 5-Socket Connector Switch Kit WARNING Battery terminals or metal tools could short against metal component, causing sparks. Sparks can cause the battery gasses to explode, resulting in personal injury. • When removing or installing the battery, do not allow the battery terminals to touch any metal parts of the machine. • Do not allow metal tools to short between the battery terminals and metal parts of the machine.
PAGE 3
Circuit Identification Table Switch contact circuits Record the wire insulation color in the space below: Z (example) PINK (example) A B (mark the 5-socket connector wire) C (mark the 5-socket connector wire) g234487 D Figure 2 E 2. 3. 1. Adapter wire harness Use electrical tape to mark the wires of the 5-socket connector aligned with the PTO switch circuit B and C contacts (Figure 1). 2. Removed wires Remove the 5-socket connector from the PTO switch. 2. Removing the PTO Switch 1.
PAGE 4
. Insert the wire into the butt-splice connector and crimp the connector (Figure 3). 5. Use a heat gun to shrink the insulator of the butt-splice connector 6. Repeat steps 3 through 5 for the remaining wires of the PTO switch circuits (Figure 3). Assembling the Wire-Harness Adapter to the PTO Switch 1. Identify the keyway slots in the new and old PTO switches (Figure 4). g234570 Figure 5 1. Contact—circuit-C (tape) 5. Contact—circuit-E 2. Contact—circuit-B (tape) 6. Contact—circuit-A 3.
PAGE 5
6. 7. Connecting the Battery Using the circuit identification table in Removing the 5-Socket Connector (page 2), assemble the ring terminals of the wire-harness adapter for switch contact circuits C (marked with tape) onto the new PTO switch with the machine screw and lock washer (Figure 6). Connect the negative-battery cable to the battery; refer to the Operator’s Manual for your machine.
PAGE 6
Notes:
PAGE 7
Notes:
PAGE 8