Parts Catalogue

ManualsBrandsToro ManualsUtility VehicleToro 132-3137

 NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain

these Installation Instructions for future reference.

Arctic Cat

ATV/Prowler

Installation Instructions - Accessory Kit

Form No. 0453-592

4-Season Clutch Kit

(p/n 1436-332/333/614)

1436-614/332 kit includes:

p/n QTY DESCRIPTION

0823-295 8 Roller

0823-292 1 Spacer

0453-592 1 Instructions

1436-333 kit includes:

p/n QTY DESCRIPTION

0823-292 1 Spacer

0453-592 1 Instructions

 NOTE: It is recommended that this kit be

installed by an authorized Arctic Cat ATV dealer.

 NOTE: Refer to the appropriate Arctic Cat ATV/

ROV Service Manual for more specific instruc-

tions.

1. On Prowler models, remove the seats and center

console and floor; then remove the left-side seat-

base. Retain all hardware.

 NOTE: On Prowler HDX models, remove the seat,

seat base, and floor. Retain all hardware.

2. On ATV models, remove the right-side footwell.

Retain all hardware.

3. Remove the machine screws securing the V-belt

cover. Retain all machine screws.

4. Remove the nut and flat washer securing the drive

clutch. Retain nut and flat washer. See Fig. 1.

 NOTE: The clutch assembly must be cleaned

before proceeding.

Fig. 1

ATV-1150

5. Remove the movable drive face and spacer. See

Fig. 2.

Fig. 2

ATV-1151

6. Remove the movable drive face plate; then remove

and retain existing rollers.

7. Install new Rollers. See Fig. 3.

Fig. 3

ATV-1152A

8. Install new Spacer and existing spacer. See Fig. 4.

Fig. 4

ATV-1153A

Summary of content (2 pages)

PAGE 1
Form No. 0453-592 Arctic Cat® ATV/Prowler Installation Instructions - Accessory Kit 4-Season Clutch Kit (p/n 1436-332/333/614)  NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain these Installation Instructions for future reference. 1436-614/332 kit includes: p/n 0823-295 0823-292 0453-592 QTY 8 1 1 Fig.
PAGE 2
Fig. 7 CAUTION Release the belt tension by installing a machine screw (removed in step 2) into the driven pulley until the pulley is completely opened or damage may occur. 9. Install existing movable drive face plate; then install movable drive face onto clutch housing. See Fig. 5. Fig. 5 GZ075  NOTE: At this time remove the machine screw from the driven pulley. 11. Rotate the V-belt and drive clutch and driven pulley until the V-belt is properly seated in the driven pulley.