Parts Catalogue

 NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain

these Installation Instructions for future reference.

Arctic Cat

Prowler

Installation Instructions - Accessory Kit

Form No. 0453-919

HDX Box Enclosure Kit

(p/n 1436-930)

Kit includes:

p/n QTY DESCRIPTION

N/A 1 Box Enclosure

1541-002 1 Front Aluminum Support Tube

1541-003 1 Rear Aluminum Support Tube

1541-004 2 Webbing Straps w/ Plastic Retainers

1514-005 2 Webbing Straps w/Release Buckles

1541-006 2 Hinge

1423-011 4 Machine Screw

2441-299 2 Jaw Slide

0453-919 1 Instructions

1. Fasten the cargo box mount to the top edge of the

cargo box using the supplied screws. The inside of

the mount should be even with the inside edge of

the cargo box. Secure the mount centered at 21.5

inches. from the rear of the front handle on top of

the cargo box edge. See Fig. 1.

Fig. 1

ROV-346A

2. Remove the machine screws from the underside of

the tailgate. Thread strap between bed and tailgate.

Install strap using the same screw going through

the hole in the strap. Be sure to install the corre-

sponding buckle strap as it mates to the buckle on

the enclosure. See Fig. 2.

Fig. 2

ROV-335A

3. Wrap the front webbings around the front bed sup-

port bar. Fully connect overlap Velcro. Velcro

around the front bar should be adjusted to the top

when spacers for the cab are in the front of the

bed. Lower when not. See Fig. 3.

Fig. 3

ROV-349A

PAGE 1
Form No. 0453-919 Arctic Cat® Prowler Installation Instructions - Accessory Kit HDX Box Enclosure Kit (p/n 1436-930)  NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain these Installation Instructions for future reference.
PAGE 2
4. Feed the front/side webbing around the cargo box and thread the end of the strap through the buckle. See Fig. 4. Fig. 4 6. Remove the tailgate latch bolt on the rear edge of the cargo box and replace going through the hole in the webbing with the plastic retainer. See Fig. 6. Fig. 6 ROV-348A 5. Raise the enclosure and connect side webbing/Velcro wraps through the tie-down access holes on the bed. To raise the front bow, pull up evenly to allow the poles to telescope. See Fig. 5. Fig. 5 ROV-351 7.
PAGE 3
8. Connect the buckles on the bed enclosure to the webbing/buckle straps attached to the tailgate. To stow the enclosure; push the buttons to collapse the side down and use the Velcro wraps to secure.