Parts Catalogue

 NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain

these Installation Instructions for future reference.

Arctic Cat

Prowler

Installation Instructions - Accessory Kit

Form No. 0453-747

LXC Windshield Washer Kit

(1436-523)

Kit includes:

p/n QTY DESCRIPTION

2441-262 1 Tank (A)

2441-263 1 90 ° Adaptor (B)

2441-264 1 Check Valve (C)

N/A 2 Machine Screw (D)

N/A 2 Washer (E)

2441-265 1 Sprayer (F)

N/A 6 Cable Tie (G)

2441-266 1 Washer Tube (H)

N/A 2 Nut (I)

2441-267 1 Pump

2441-268 1 Wire Harness

0453-747 1 Instruction

1. Open the hood; then cut 8-in. of Washer Tube and

install it on pump until it is fully seated.

2. Install Check Valve to the other side of the 8-in. washer

tube making sure the arrow is in the direction flowing

away from the Tank. See Fig. 1.

Fig. 1

UTV-232

3. Install the rest of the washer tube on the other side

of the check valve.

4. Place the tank into the operator’s side of the under-

hood storage box and mark both mounting loca-

tions.

5. Remove the tank and using a 1/4-in. drill bit, drill

both mounting locations. See Fig. 2.

Fig. 2

UTV-233

6. Connect both the black and red wires to the pump

mounted on the back of the tank; then secure the

tank to the storage box using two Machine Screws,

two Washers, and two nuts. Tighten securely. See

Fig. 3.

Fig. 3

UTV-234

PAGE 1
Form No. 0453-747 Arctic Cat® Prowler Installation Instructions - Accessory Kit LXC Windshield Washer Kit (1436-523)  NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain these Installation Instructions for future reference. Kit includes: p/n 2441-262 2441-263 2441-264 N/A N/A 2441-265 N/A 2441-266 N/A 2441-267 2441-268 0453-747 QTY 1 1 1 2 2 1 6 1 2 1 1 1 4.
PAGE 2
7. Make sure all wires are between the dash and the gutter of the storage box. Use cable ties to maintain all wires. See Fig. 4. 10. Route the washer tube from the pump under the dash and up along the left-side ROPS tube and toward the wiper motor. 11. Remove the plug above the wiper motor; then install 90° Adaptor into the windshield; then connect the washer tube to the adaptor. See Fig. 6. Fig. 4 Fig. 6 UTV-235A 8.