Parts Catalogue

 NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain

these Installation Instructions for future reference.

Arctic Cat

Prowler

Installation Instructions - Accessory Kit

Form No. 0453-746

LXC Windshield Wiper Kit

(1436-522)

Kit includes:

p/n QTY DESCRIPTION

2441-269 1 Wiper Motor (A)

2441-270 1 Wiper Arm (B)

2441-271 1 Black Wire (C)

2441-272 1 Red Wire (108 1/4-in.) (D)

2441-273 1 Jumper Wire (E)

2441-274 1 Accessory Wire-Jumper (F)

(23 5/8-in.)

2441-275 1 Loom (G)

2441-276 1 Switch (H)

2441-277 1 Blade (I)

N/A 6 Cable Tie (J)

0453-746 1 Instruction

 NOTE: Make sure the key is in the off position

while installing this kit.

1. With the windshield kit installed on the vehicle, remove

the three lower caps from the middle of the windshield.

See Fig. 1.

Fig. 1

UTV-223A

2. Position Wiper Motor through the three holes in

the windshield; then secure the motor using three

flat washers and three nuts.

3. Install Blade onto Wiper Arm; then secure the arm

and the upper portion of the wiper motor to the

windshield (at a 90° angle) using one nut. Finger

tighten at this time. See Fig. 2.

Fig. 2

UTV-224A

4. Install the Black and Red Wire (108 1/4-in.) into

Loom; then plug the wires into the wiper motor.

See Fig. 3.

Fig. 3

UTV-226A

PAGE 1
Form No. 0453-746 Arctic Cat® Prowler Installation Instructions - Accessory Kit LXC Windshield Wiper Kit (1436-522)  NOTE: Read these Installation Instructions thoroughly before beginning the installation process. Retain these Installation Instructions for future reference. Kit includes: p/n QTY 2441-269 2441-270 2441-271 2441-272 2441-273 2441-274 1 1 1 1 1 1 2441-275 2441-276 2441-277 N/A 0453-746 1 1 1 6 1 2.
PAGE 2
5. Route the loom along the upper portion of the windshield and down along the left-side ROPS tube. Loosely secure using cable ties. See Fig. 4. 9. Route the accessory wire-jumper through the dash and plug it into the upper left switch connection (#4). See Fig. 7. Fig. 4 Fig. 7 UTV-252 10. Route the red wire through the dash and plug it into the lower left switch connection (#3). UTV-227A 6. Route the wiper motor wires on the left side of the dash and route to the switch panel in the dash. 11.
PAGE 3
 NOTE: If the wiper arm is too long, release the lever on the underside of the arm and shorten the length of the arm. Secure the lever when the desired length is achieved. See Fig. 10. Fig. 9 Fig. 10 OHUV-054  NOTE: If the wiper blade is not centered properly while sweeping, turn off the wiper motor and ignition switch. Pull the wiper arm/blade assembly off the shaft and adjust it until it is centered while sweeping.