Installation Instructions

FormNo.3384-497RevA

HoseServiceKit

STX-38StumpGrinder

ModelNo.131-0600

InstallationInstructions

Installation

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

InstallingtheHose

Partsneededforthisprocedure:

1Hydraulichose

Adaptertting

1Hexplug

Teetting

1.Movethemachinetoalevelsurface,shutoffthe

engine,andremovethekeyfromthekeyswitch.

2.Allowtheengineandcoolingsystemtocool.

3.Removethetoppanelofthemachine(Figure1).

g025864

Figure1

1.Toppanel

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3384-497*A

PAGE 1
Form No. 3384-497 Rev A Hose Service Kit STX-38 Stump Grinder Model No. 131-0600 Installation Instructions Installation WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. 1 Installing the Hose 1 Parts needed for this procedure: 1 Hydraulic hose 1 Adapter fitting 1 Hex plug 1 Tee fitting g025864 1.
PAGE 2
11. Install the breather on top of the tee and tighten to hand-tight (Figure 3). 4. Remove the case drain hydraulic hose routed between the cutter motor and control valve (Figure 2). 12. Install the hydraulic hose to the fitting on the motor case drain and torque to 37 to 45 N-m (27 to 33 ft-lbs) (Figure 4) Note: Keep the hydraulic hose ports clean from debris. Note: Keep the hydraulic hose ports clean from debris. 1 1 g025867 g025865 Figure 2 Figure 4 1. Case drain hydraulic hose 1.