Installation Instructions

FormNo.3373-603RevA

MotionControlLinkKit

XLSLawnTractor

ModelNo.121-4040

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Tractionbracketlinkarm1

Frontmotioncontrollinkarm1

Rearmotioncontrollinkarm1

Flatwasher2

Hairpincotter2

Shoulderbolt

Pivotwasher1

Locknut(5/16inch)

Installmotioncontrollinkkit

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

*3373-603*A

PAGE 1
Form No. 3373-603 Rev A Motion Control Link Kit XLS Lawn Tractor Model No. 121-4040 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Traction bracket link arm Front motion control link arm Rear motion control link arm Flat washer Hairpin cotter Shoulder bolt Pivot washer Locknut (5/16 inch) © 2012—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Qty. 1 1 1 2 2 1 1 1 Register at www.Toro.com.
PAGE 2
1. Stop the engine, wait for all moving parts to stop, and remove the ignition key. 3. Install the traction bracket link arm using the locknut (5/16 inch), pivot washer and shoulder bolt (Figure 2). 2. Remove the exiting motion control link arm (Figure 1). Save the existing clevis pin, hairpin cotter and E-clip. 1 Note: E-clip is spring loaded. 5 4 3 2 2 1 3 g018844 4 Figure 2 g018864 Figure 1 1. Post 4. Existing clevis pin 2. Existing E-clip 5. Existing hairpin cotter 3.
PAGE 3
6 4. Install the rear motion control link arm using the flat washer and hairpin cotter (Figure 3) supplied with this kit and the existing E-clip from step 2. 7 5 5 4 4 3 8 3 2 7 1 8 6 2 4 5 1 3 9 g018843 Figure 4 g018842 Figure 3 1. Hairpin cotter 2. Flat washer 3. Post 5. Rear motion control link arm 6. Traction bracket link arm 7. Hole nearest outer edge 1. Hairpin cotter 6. Existing clevis pin 2. Flat washer 7. Existing hairpin cotter 3. Rear motion control link arm 4.
PAGE 4
Notes: 4