Installation Instructions

FormNo.3373-130RevA

ReplacementHoodKit

XLSLawnTractor

ModelNo.121-4011

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Hood1

Flatwasher2

Screwselftapping1/4x0.75

Installhood

Partsneededforthisprocedure:

1Hood

2Flatwasher

Screwselftapping1/4x0.75

Procedure

1.Raisetheexistinghood(Figure1).

2.Disconnectthewireharnesslocatedontheleftside.

3.Removethe4screwssecuringthehoodtotheframe.

Removethehood.Savethesescrews.

g018208

Figure1

1.Raisedhood3.Frame

2.Wireharness

4.Screwssecuringthehood

4.Removethe4screwssecuringtheairducttothe

existinghood.Removetheairductanddiscardscrews

(Figure2).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3373-130 Rev A Replacement Hood Kit XLS Lawn Tractor Model No. 121-4011 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 Description Use Qty. Hood Flat washer Screw self tapping 1/4 x 0.75 1 2 12 Install hood 1 2 Parts needed for this procedure: 1 Hood 2 Flat washer 12 Screw self tapping 1/4 x 0.75 4 Procedure 1 3 g018208 Figure 1 1. Raise the existing hood (Figure 1). 2.
PAGE 2
4 5 6 3 2 7 9 1 8 3 5 4 6 7 g0118215 Figure 2 1. Air duct 6. Outside screw securing the headlight (save these existing screws) 2. Self tapping screw 7. Self tapping screw securing the trim and the front end assembly 3. Trim 8. Inside screw securing the headlight (discard these screws) 4. Self tapping screw securing the trim (install the new flat washers here) 9. Front end assembly 5. Headlight 5. Remove the 6 screws securing the trim and front end assembly.