Installation Instructions

ManualsBrandsToro ManualsBlowers/VacuumsController Relocation Kit, Pro Force Debris Blower

FormNo.3371-856RevA

ControllerRelocationKit

ProForceDebrisBlower

ModelNo.121-2811

InstallationInstructions

1.Disconnectthenegativebatterycablerstandthen

disconnectthepositivebatterycable.

2.Disconnectthewireharnessconnectorsfromthe

wirelesscontrolunit(

Figure1).

g017839

Figure1

1.Wirelesscontrolunit2.Wireharnessconnectors

3.Removethe(3)screwsandnutssecuringthewireless

controlunittotheblowerframe(Figure1).Remove

thecontrolunit.

4.Mountthewirelesscontrollerunittothecontroller

platewith(3)1/4x1–1/2inchscrewsandange

nuts(

Figure2).

5.Plugthewireharnessextensionintothewireless

controllerunit(

Figure2).

g017837

Figure2

1.Flangenut

4.Controllerwireharness

extension

2.Controllerplate5.Screw,1/4x1–1/2inch

3.Wirelesscontrollerunit

6.Remove(2)ofthescrewsandnutssecuringthe

blowerhousingtotheinletring(Figure3).Thiswill

bethemountinglocationforthecontrollerplateand

wirelesscontrolunit.

g017838

Figure3

1.Screw,5/16x1–1/2inch4.Controllerunitassembly

2.Flatwasher5.Wireharnessextension

3.Flangenut

6.Cableties

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3371-856 Rev A Controller Relocation Kit Pro Force Debris Blower Model No. 121-2811 Installation Instructions 1. Disconnect the negative battery cable first and then disconnect the positive battery cable. g017837 2. Disconnect the wire harness connectors from the wireless control unit (Figure 1). 1 2 1 2 3 4 5 Figure 2 1. Flange nut 4. Controller wire harness extension 5. Screw, 1/4 x 1–1/2 inch 2. Controller plate 3. Wireless controller unit g017839 Figure 1 1. Wireless control unit 2.
PAGE 2
7. Mount the controller plate to the back side of the blower housing with (2) 5/16 x 1–1/2 screws, flat washers and flange nuts (Figure 3). 8. Plug the wire harness extension into the existing wire harness. 9. Secure the wire harness extension to the blower with (3) cable ties. 10. Connect the positive battery cable first and then connect the negative battery cable.