Installation Instructions

ManualsBrandsToro ManualsSprayersPump Mount Kit, Multi-Pro 5800 Turf Sprayer

FormNo.3370-128RevA

PumpMountKit

Multi-Pro5800TurfSprayer

ModelNo.120-8561

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Flatwasher

Hex-headbolt(5/16x3inches)

Flangenut(5/16inch)

Compressionspring

Installthekit.

Partsneededforthisprocedure:

Flatwasher

Hex-headbolt(5/16x3inches)

Flangenut(5/16inch)

Compressionspring

Procedure

1.Parkthemachineonalevelsurface,stoptheengine,

engagetheparkingbrake,andremovethekeyfrom

theignitionswitch.

2.Operateallhydrauliccontrolstorelievethepressure

inthehydraulicsystem.

3.Removethe2angenutsthatsecuretherubber

vibrationmounttothemotormountplate,and

removetherubbervibrationmount(

Figure1).

G016996

Figure1

1.Motormountplate3.Rubbervibrationmount

2.Flangenut

Note:Discardtherubbervibrationmountandthe

nut.

4.Slidethewasherontothedamperboltandinsert

themintothevibrationmountholeonthespray

pumpmountbracket(

Figure2).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

Summary of content (2 pages)

PAGE 1
Form No. 3370-128 Rev A Pump Mount Kit Multi-Pro 5800 Turf Sprayer Model No. 120-8561 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 Description Use Qty. 5 1 1 2 Flat washer Hex-head bolt (5/16 x 3 inches) Flange nut (5/16 inch) Compression spring Install the kit. 1 1 Parts needed for this procedure: 5 Flat washer 1 Hex-head bolt (5/16 x 3 inches) 1 Flange nut (5/16 inch) 2 Compression spring 2 3 G016996 2 Procedure 1.
PAGE 2
6 G016902 1 2 3 2 3 2 4 5 Figure 2 1. Flange nut 4. Damper bolt 2. Washer 5. Pump mount bracket 3. Compression spring 6. Motor mount plate 5. Slide the following parts onto the damper bolt in the following order: a washer (part no. 3256-23), a spring (part no. 110-5331), and a washer (part no. 3256-23) (Figure 2). 6. Insert the damper bolt (with the parts listed in step 5) into the plate hole (Figure 2). 7.