Installation Instructions

ManualsBrandsToro ManualsSprayersBeacon Kit, Multi-Pro 5800 Turf Sprayer

FormNo.3369-425RevA

BeaconKit

Multi-Pro

5800TurfSprayer

ModelNo.120-8505

InstallationInstructions

Safety

SafetyandInstructionalDecals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyareaof

potentialdanger.Replaceanydecalthatisdamagedorlost.

120-0771

1.Beaconlight

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Wireharness1

Beaconswitch1

Installthewireharnessandswitch.

Beaconbracket1

Beaconsocketwithconnector1

Beacon1

U-bolt2

Locknut(3/8inch)

Assembleandmountthebeacon.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

Summary of content (4 pages)

PAGE 1
Form No. 3369-425 Rev A Beacon Kit Multi-Pro® 5800 Turf Sprayer Model No. 120-8505 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 120-0771 1. Beacon light Installation Loose Parts Use the chart below to verify that all parts have been shipped.
PAGE 2
1 Installing the Beacon Switch Parts needed for this procedure: 1 Wire harness 1 Beacon switch G017102 Figure 2 Procedure 1. Grounding block 1. Remove the plug from the switch mounting hole in the dash (Figure 1). 1 2. Fuse block 7. Plug the wire harness connector into the fuse block. 2 Note: If there are no available power terminals on the fuse block, the Fuse Block Kit (92-2641) may be purchased separately from your Toro Distributor. 8.
PAGE 3
1 7. Mount the beacon assembly to the beacon bracket (Figure 4). 3 2 8. Plug the beacon onto the socket and tighten the wing nut (Figure 4). G016775 4 Figure 3 1. Beacon 2. ROPS bar 3. U–bolts 4. Locknuts 4. Remove the beacon connector from the beacon socket (Figure 4). 1 2 3 4 5 6 g017101 Figure 4 1. Beacon 2. Beacon connector 3. Beacon socket 4. Beacon bracket 5. Washer 6. Jam nut 5.
PAGE 4
Maintenance Maintenance Tips • Verify that the bulb is functional and that the reflector rotates properly. • Clean the beacon regularly with a non petroleum-based cleaner. • Always verify that the beacon is secured firmly to the sprayer before use. • Ensure that the drain slots are kept clear of debris. • If the machine is going to be stored outdoors, verify that the lens is secured properly to prevent water from entering the beacon.