Installation Instructions

Form No. 3355-402 Rev A
Spindle Kit
For Z Master® Mowers with 72in Cutting Unit
Model No. 112-5024
Installation Instructions
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Prepare the mower.
2
No parts required
–
Remove the existing spindle.
Spindle assembly
1
Bolt, (3/8 x 3/4 inch)
3
Blade bolt, (5/8 x 2–1/4 inches)
1
Small curved washer
3
3
Large curved washer (blade bolt)
1
Install the new spindle.
4
Template
1
Modify the belt covers.
Step
1
Preparing the Mower
No Parts Required
Procedure
1. T horoughly clean mo w er dec k. All debris m ust
be remo v ed to ensure spindle will fit properly
ag ainst mo w er dec k.
2. R e pair all bent or damag ed areas of mo w er
dec k and re place any missing par ts .
Step
2
Removing the Existing
Spindle
No Parts Required
Procedure
1. R emo v e the belt co v ers from the mo w er dec k.
2. R emo v e the mo w er belt from the pulleys on
the mo w er dec k.
3. R emo v e the three bolts holding the dec k pulley
to the alumin um hub . Sa v e the dec k pulley and
discard the bolts ( Figure 1 ).
4. Raise the front of the mac hine and suppor t it
with a Z Stand® and jac k stands .
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved