Installation Instructions

ManualsBrandsToro ManualsSprayersFootswitch Upgrade Kit, Multi-Pro 5600 Turf Sprayer

Form No. 3354-831 Rev A

Footswitch Upgrade Kit

For Multi-Pro 5600 Turf Sprayer

Model No. 110-5076

Installation Instructions

Installation

Loose Parts

Use the chart below to verify that all parts have been shipped.

Step

Description

Qty.

Use

No parts required

–

Prepare the machine.

No parts required

–

Remove the foot switch.

Floor switch

Wiring harness

Hex-head screw (1/4 inch)

Lock washer (1/4 inch)

Nut (1/4 inch)

Wire tie

Install the oor switch.

Step

Preparing the Machine

No Parts Required

Procedure

1. P ark the spra yer on a ﬂat surface , lo w er the

booms , set the parking brak e , stop the engine ,

and remo v e the k ey .

2. Disconnect batter y neg ati v e cable .

Step

Removing the Foot Switch

No Parts Required

Procedure

1. Disconnect Spra yer F oot Switc h connector

under ﬂoor pan.

2. R emo v e the retaining n ut and remo v e the

spra yer foot switc h from the ﬂoor pan. Discard

the foot switc h.

3. R emo v e the bolt securing the left side of

the front hood to the ﬂoor pan to allo w the

existing ﬂoor switc h wiring to be brought

abo v e the ﬂoor pan ( Figure 1 ).

8111 Lyndale Avenue South

Bloomington, MN 55420

Printed in the USA.

Summary of content (4 pages)

PAGE 1
Footswitch Upgrade Kit Form No. 3354-831 Rev A For Multi-Pro 5600 Turf Sprayer Model No. 110-5076 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Step 1 2 3 Description Use Qty. No parts required – Prepare the machine. No parts required – Remove the foot switch. Floor switch Wiring harness Hex-head screw (1/4 inch) Lock washer (1/4 inch) Nut (1/4 inch) Wire tie 1 1 2 2 2 4 Install the oor switch.
PAGE 2
(1/4 inch) and two nuts (1/4 inch) provided in loose parts (Figure 2). Figure 1 1. Front hood, left side 2. Floor pan 3. 4. Bolt Existing oor switch wiring Figure 2 1. New oor switch 2. Hex head screw (1/4 inch) 4. After the wiring is above the ﬂoor pan reinstall the front hood and secure it with the cover bolt. 3. 4. Lock washer (1/4 inch) Nut (1/4 inch) 4. Connect the three prong connector on the new wiring harness to the three prongs on the ﬂoor switch. Step 3 5.
PAGE 3
6. Use wire ties to secure the relays and harness to the frame under the dash as shown in (Figure 3). 7. Reconnect the battery. 8. Test for proper ﬂoor switch function.
PAGE 4