Installation Instructions

Form No. 3354-107 Rev A
Discharge Door Seal Kit
Model No. — All 2005 and after Super Recycler Lawn Mower M odels
Installation Instructions
Installing the Door Seals
Parts needed for this step:
2
Door seals
Procedure
1. Install the seal onto one of the two top edges
on the discharg e door (Figure 1).
1
2
1
2
G001299
Figure 1
1. Seal 2. Top edge
Note: Start on the outer end of the edge and
work your way inward, using your thumb to
firmly push the seal onto the edge.
2. Install the other seal onto the other top edge
of the discharg e door.
Installing the F oam Side
Pieces
Parts needed for this step:
1
Foam piece
Procedure
1. Cut the foam piece in half so that you have two
1-inch by 1-1/2–inch pieces.
2. Remove the protective backing from one of
the foam pieces to expose the adhesive.
3. Lift up the rear discharge door.
4. Attach a foam piece to one of the cor ners on
the inside of the discharge door (Figure 2).
1 1
G001300
Figure 2
1. Foam piece
5. Removetheprotectivebackingfromtheother
foam piece and attach it to the other corner on
the inside of the discharge door (Figure 2).
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 554 20
Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved