Installation Instructions

ManualsBrandsToro ManualsSnow ThrowerToro 108-7308

W 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Chute Ring Kit

For Power Shift and Power Throw XL Snowthrowers

Part No. 108-7308

Form No. 3352-971

Installation Instructions

1. Remove the chute assembly by removing the chute

retainers, chute retainer plates, screws, and locknuts

(Fig. 1).

m-168

Figure 1

1. Discharge chute

2. Chute retainer (3)

3. Chute retainer plate (3)

4. Chute ring

5. Screw (3)

6. Locknut (3)

2. Remove the worm gear, gear bracket, chute gear rod,

carriage bolt, flat washer, and locknut (Fig. 2).

170

Figure 2

1. Gear bracket

2. Carriage bolt, flat washer,

and locknut

3. Mounting flange

4. Chute gear rod

5. Worm gear

3. Chisel the weld and the remaining chute ring from the

chute opening of the auger housing.

4. Grind the surface clean of excess weld and paint the

surface.

5. Slide the new chute ring onto the chute opening and

position it so that it is 1-1/4 inches (3.2 cm) from the

top of the chute opening (Fig. 3).

1-1/4 in. (3.2 cm)

Figure 3

1. Chute ring

6. Weld the chute ring to the chute with 4 fillet welds

(1/8-inch) that are 1 inch long and 90 degrees apart.

7. Grind or scrape any weld splatter or excess weld from

the chute ring to allow the chute and retainers to freely

rotate.

8. Paint the areas where you removed any paint.

Summary of content (2 pages)

PAGE 1
Form No. 3352-971 Chute Ring Kit For Power Shift and Power Throw XL Snowthrowers Part No. 108-7308 Installation Instructions 1. Remove the chute assembly by removing the chute retainers, chute retainer plates, screws, and locknuts (Fig. 1). 3. Chisel the weld and the remaining chute ring from the chute opening of the auger housing. 4. Grind the surface clean of excess weld and paint the surface. 5. Slide the new chute ring onto the chute opening and position it so that it is 1-1/4 inches (3.
PAGE 2
Installing the Discharge Chute Installing the Chute Control Worm Gear 1. Apply a light coat of low-temperature grease to the chute ring (Fig. 4). 1. Insert the 1-inch (2.5 centimeters) carriage bolt into the mounting hole of the gear bracket (Fig. 2). 1 5 5 2 1 3 6 4 4 2 m-168 170 Figure 4 1. Discharge chute 2. Chute retainer (3) 3. Chute retainer plate (3) 3 Figure 5 4. Chute ring 5. Screw (3) 6. Locknut (3) 1. Gear bracket 2. Carriage bolt, flat washer, and locknut 2.