Installation Instructions

ManualsBrandsToro ManualsSprayersReplacement Belt Kit, Multi-Pro 1200 and 1250 Turf Sprayers

W 2005 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Replacement Belt Kit

for Multi Pro

)

1200 and 1250 Turf Sprayers

Model No. 108-3654

Form No. 3353-475 Rev A

Installation Instructions

Note: Determine the left, right, front, and rear sides of the machine while seated in the normal operating position.

Note: A 5/8 inch crow foot wrench with a 9 inch or longer ratchet extension or equivalent tools are recommended for the

installation of this kit.

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION

QTY. USE

Belt, drive 1 Install the belt

Installation instructions 1 Read before installing the kit.

Preparing the Machine

1. Position the sprayer on a level surface, set the parking

brake, stop the pump, stop the engine, and remove the

ignition key.

2. Empty the contents of the tank. Refer to the Operator’s

Manual for more information.

Chemicals are hazardous and can cause personal

injury.

• Read the directions on the chemical labels

before handling the chemicals and follow all

manufacturer recommendations and

precautions.

• Keep chemicals away from your skin. Should

contact occur, wash the affected area thoroughly

with soap and clean water.

• Wear goggles and any other protective

equipment recommended by the chemical

manufacturer.

Caution

3. Remove the front agitation hose on the tank to allow

access to drive belt. Use caution to avoid exposure to

residual chemicals in the hose when removing it

(Fig. 1).

Figure 1

1. Primary clutch 2. Agitation hose

4. Rest the agitation hose above the heat shield while

installing the new belt.

Installing the Belt

1. Use a 5/8 inch crow foot wrench with a 9 inch extension

or an equivalent to loosen the bolts securing the belt

guides to the engine (Fig. 2).

2. Rotate the upper belt guide upward to a vertical position

so that it will not interfere with any parts (Fig. 2).

Summary of content (2 pages)

PAGE 1
Form No. 3353-475 Rev A Replacement Belt Kit for Multi Pro) 1200 and 1250 Turf Sprayers Model No. 108-3654 Installation Instructions Note: Determine the left, right, front, and rear sides of the machine while seated in the normal operating position. Note: A 5/8 inch crow foot wrench with a 9 inch or longer ratchet extension or equivalent tools are recommended for the installation of this kit. Loose Parts Note: Use the chart below to identify parts for assembly. QTY.
PAGE 2
Note: If desired, the belt guides can be removed with the removal and installation of the primary clutch. It is not necessary for the installation of this kit. 3. Tighten the bolt to secure the guide in the new position. Torque the bolts to 50 lb-ft (68 N⋅m). 4 m–8181 3 2 1 6 5 Figure 2 1. 2. 3. 4. Primary clutch Engine Secondary clutch Belt guide, rotated vertical 5. Belt guide, rotated to engine mount plate 6. Engine mount plate 4. Rotate the lower guide to rest on the engine mount pan. 5.