Installation Instructions

FormNo.3353-323RevB

TurretSealRepairKit

forMulti-Pro

1200,1250,5700-DandWorkman

200SpraySystem

ModelNo.108-3263

InstallationInstructions

Note:Asiliconbasedlubricantornon-petroleum

basedlubricant,suchasvegetableoil,willberequired

fortheinstallationofthiskit.

Removetheturretsprayerfromthemachinetofacilitate

theinstallationofthiskit.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Determineyourturretversion.

O-ring,large(108-3267)

O-ring,small(108-3267)

Diaphragm(108-3267)

O-ring,medium(108-3267)

Vitonseal(108-3266)

VitonO-ring(108-3266)

Replacingtheturretseals.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA.

AllRightsReserved

PAGE 1
Form No. 3353-323 Rev B Turret Seal Repair Kit for Multi-Pro® 1200, 1250, 5700-D and Workman® 200 Spray System Model No. 108-3263 Installation Instructions Note: A silicon based lubricant or non-petroleum based lubricant, such as vegetable oil, will be required for the installation of this kit. Remove the turret sprayer from the machine to facilitate the installation of this kit. Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty.
PAGE 2
• Models with a “QJ360C” revision level will have a “QJ360C” on the turret plug face and “363” on the turret arms as shown in Figure 2. Use the bag with part number 108-3266 to replace the Viton seal and O-ring at the base of the turret body. 1 Determining your Turret Version G009490 No Parts Required 1 Procedure 3 2 This kit consists of two bags with different parts in each bag. The bag with part number 108-3267 contains O-rings and a diaphragm that can be used on all turrets.
PAGE 3
1. Disassemble turret sprayer as shown in Figure 3. 2 2. Replace the small O-ring in the turret plug. 3. Replace the two large O-rings sealing turret to manifold body. Replacing the Turret Seals 4. Replace the mid-size O-ring in the clamp assembly. Parts needed for this procedure: 5. Replace the diaphragm in the end cap. 6.
PAGE 4