Installation Instructions

 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Electric Service Module Kit

for T-Bar Mid–Size Mowers

Part No. 107-4113

Form No. 3351–544

Installation Instructions

This kit can be installed on all T–Bar machines.

Loose Parts

Note: Use the chart below to identify parts for assembly.

Description Qty. Use

Electric module assembly 1 Installing the electric service module

Removing the Existing Module

1. Stop the machine, engage the parking brake, turn the

engine off and remove the key.

2. Disconnect the negative battery cable from the battery if

installing on an electric start unit.

3. Remove the screws securing the control panel cover to

the underside of the control panel (Fig. 1).

m–7631

Figure 1

1. Screw

2. Control panel cover

3. Control panel

4. Locate the relay shown in the Figure 2. Remove the

fasteners securing the relay to the control panel cover.

Save the fasteners for later use.

m-7632

Figure 2

1. Control panel cover

2. Relay module

3. Fastener

4. Flat, square connector

5. Bullet connector, brown

5. Remove the relay module from the wiring harness by

disconnecting male end of the flat, square connector and

the brown wire bullet plug from the wiring harness

(Fig. 2).

PAGE 1
Form No. 3351–544 Electric Service Module Kit for T-Bar Mid–Size Mowers Part No. 107-4113 Installation Instructions This kit can be installed on all T–Bar machines. Loose Parts Note: Use the chart below to identify parts for assembly. Description Qty. Electric module assembly 1 Removing the Existing Module 1. Stop the machine, engage the parking brake, turn the engine off and remove the key. Use Installing the electric service module 4. Locate the relay shown in the Figure 2.
PAGE 2
6. Cut the wires connecting the female end of the flat, square connecter at the base of the connector (Fig. 3). 4. Connect the female end of the electric service module to the male connector installed previously (Fig. 5). Important Pull out on the connector ensure the wires are cut close to connector. This allows enough wire for the insulation to be cut back and the new connector installed. 5.