Installation Instructions

 2003 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

CE Decal Kit

107cm/122cm Vacuum Bagger for XT Series

GardenTractors

Part No. 107–3698

Form No. 3350–962

Installation Instructions

Installing the Decals

Install the decals in the positions indicated in the table and

graphics below. Place each International decal directly over

the corresponding US English decal.

Install each decal as follows:

1. Thoroughly clean the area where you will install the

decal.

2. Dampen the area with water or mildly soapy water.

3. Peel the decal from the backing and install it in place.

4. Squeegee across the surface of the decal, starting at the

center of the decal and working toward the edges, using

overlapping strokes.

Installing the Sound Decal on

the Mower Deck

Note: The 105 dB sound decal is installed on either the

107cm belt cover or the 132cm mower.

Install the sound decal to the correct belt cover as shown in

Figure 1.

Installing the Decals

m–7291

1 4

Front View of Bagger Hood

19mm

107cm Cover

122 cm Cover

Figure 1

1. Noise decal, 105–4674

2. Decal, 93–7814

3. Decal, 93–6658

4. Decal, 93–7317

5. Decal, 93–7316 6. Decal, 93–7320

PAGE 1
Form No. 3350–962 CE Decal Kit 107cm/122cm Vacuum Bagger for XT Series GardenTractors Part No. 107–3698 Installation Instructions Installing the Decals 4. Squeegee across the surface of the decal, starting at the center of the decal and working toward the edges, using overlapping strokes. Install the decals in the positions indicated in the table and graphics below. Place each International decal directly over the corresponding US English decal.
PAGE 2
Location U.S. English International No existing U.S. decal 105-4674 79–7450 93-7814 79–7460 93-6658 92–7108 93-7317 93-1122 93-7316 (See Figure 1 for the correct location) 1 2 3 Qty.
PAGE 3
Location U.S.
PAGE 4