Installation Instructions

Form No. 3324-936

Pin Kit

Part No. 104-2702

Installation

Instructions

Dingo



Vibratory Plow

Loose Parts

Description Qty. Use

Hub

Bolt

Washer

Install the pin

Removing the Old Pin

1. Swing the blade into the upright position (or remove

it) and remove the plow from the traction unit.

2. Block up the mount plate so that it will not be able to

fall when you remove the pin.

3. Remove the bolt and washer securing the pin (Fig. 1).

4. Using a hammer and punch from the bottom, remove

the old pin.

5. Clean all grease from the hole where the pin was.

m–5024

Figure 1

1. Bolt

2. Washer

3. Old pin

4. Mount plate

PAGE 1
Form No. 3324-936 Pin Kit Dingo Vibratory Plow Installation Instructions Part No. 104-2702 Loose Parts Description Qty. Pin 1 Hub 1 Bolt 1 Washer 1 Use Install the pin Removing the Old Pin 3 1. Swing the blade into the upright position (or remove it) and remove the plow from the traction unit. 2. Block up the mount plate so that it will not be able to fall when you remove the pin. 3. Remove the bolt and washer securing the pin (Fig. 1). 4.
PAGE 2
Installing the New Pin 1. Insert the new pin into the opening and push it all the way down. 6 5 4 1 7 3 2 m–5025 Figure 2 1. Pin 2. Bolt removed from the old pin 3. Washer removed for the old pin 4. 5. 6. 7. Hub Washer Bolt Grease fitting 2. Secure the pin from the bottom using the washer and bolt removed previously (Fig. 2). 3. Torque the bolt to 27 to 33 ft.-lb. (37 to 44 N⋅m). 4. Place the hub over the top of the pin so the taper in the hub seats on the taper of the pin (Fig. 2). 5.