1 “Toto . This Owner Manual has been especially prepared for your information and guidance in the operation and care of your new Toto mower.
OPERATING INSTRUCTIONS ASSEMBLY INSTRUCTION To prepare your new Sport Law for mowing, attach the lower handle section A" to the mower frame by snapping it over the handle studs "B" as shown in Figure 1. Then bolt this section to the handle stop brackets "C" with the two short bolts you will find in the plastic bag attached to the mower. Be sure handle brace "D at the upper end of this handier section A" has the flange facing down. Then insert cotter keys in holes provided in handle studs "B".
SERVICE INSTRUCTIONS CHAIN ADJUSTMENT The chain {Ref, 62, page 6) may be expected to loosen at first as the high spots are worn off, To tighten insert shires ""A"between counter shaft housing "B"and platform HCM This is easily done by loosening the four resews "D holding the counter shaft housing to ihe platform, There should be a slight amount of slack in the chain when it is properly adjusted. Be sure you do not get it too tight. See Figure 3 for this adjustment.
o 05—t IMPORTANT ORDERING To insure getting correct parts without delay, please furnish the following information: 1. 2. 3. Serial number of your mower as shown on the name plate, Part number, description and quantify of each part required. State whether parts should be shipped by mail or & IS INSTRUCTIONS express. All repair parts are shipped factory. Name and address where parts ave to be shipped. . Do not order by reference number; use part number only.
PARTS LIST Ref., No. Ref. No. No. | Part No, Description Used No. | Part No. Description Used 1 UPDIKE-166 |[Side Pate Assembly, Right 39 | PD-399 Roller Shaft 1 consisting of side plate & 40 }3256~6 Washer, 3" cut 2 outer Bearing Race 1 41 |PD-9 Nut 2 2 UPDIKE-165 |Side Plate Assembly, Left 42 | PD330A-1 | Roller Bracket, left 1 consisting of SIDS plate & 43 | 3230-6 Bolt, x2" outer Bearing Race 1 carriage 2 3 |32563-6 Lock washer, 7/16" Reg.
PARTS LIST Ref. No. Ref, No. No, | Part No. Description Used No. | Part No. Description Used) 107 | E-137-1 | Spacer, Bracket 1 125 |3310~15 | Screw, F. x 1-5/8 i 108 | 829-15 Screw, x28"Lg. 1 126 |PDX-255 | Upper Handle Says. concoct | 32616 Screw, 10-24 x 3" N.C. 1 siting of upper 110 | Washer #10 1 handle, plug buttons 111 | PD-17 Bracket, Hands Stop 2 £ Plastic Grip 1 112 ] 3210-8 Screw, 5/16" N.F. x §" 2 127 | 3350~1 Resew, Drive #0 x 3/16" 4 113 | 8218-2 Nut, 6/16" N.C.