This Owner Manual has been especially prepared for your information and guidance in the operation and care of your new Orc mower. Information on care and operation of the engine is contained in a separate manual furnished with the engine. Properly adjusted, operated and maintained, this Toto mower will respond quickly and easily to every reasonable demand and give years of reliable service, Toto mowers are manufactured by an organization of mowing machinery specialists with over forty years experience.
OPERATING INSTRUCTIONS ASSEMBLY INSTRUCTION studs "B" as shown 5 crofter keys in holes ' stop bracket (Ref. 1 purpose. SCHEMA: After the lower handle section "A' has been mounted on your Sport Lawn, you are ready to connect the two handle sections together, First insert bolt "FV in the lower handle section "A," then snide upper handle section "E' info place on the lower half and fasten with the 5/16" mu and lock washer provided in the plastic bag.
SERVICE INSTRUCTIONS CHAIN ADJUSTMENT “The chain (Ref. 62, page B} may be expected to loosen at first as the high spots are worn off. To tighten insert shims ""A"between counter shaft housing "B and platform "Cr This is easily done by loosening the four screws "D holding the counter shaft housing to the platform. There should be a enlightenment of slack in the chain when it is properly adjusted. Be sure you do not get H too tight. See Figure 3 for this adjustment.
IMPORTANT ORDERING INSTRUCTIONS To insure getting correct parts without delay, express. All repair parts are shipped F.O.B. please furnish the following information; factory. 1. Serial bummer of your mower as shown on the 4, Name and address where parts are to be shipped. name plate. 5. Do not order by reference number; use part 2. Part number, description and quantity of each number only. . part required. 6. Repair parts are available from your Toto district.
PARTS LIST Ref. No. Ref. No. No. | Part No. Description Used No. | Part No. Description Used 1 [PD-186 [Side Plate Assembly, 3% | PD-389 Roller Bharat 1 Right consisting of 40 | 3256-6 Washer, 3" cut 2 side plate & outer. 41 | PD-9 Nut 2 Bearing Race 1 42 | PD330A-1 Olivier Bracket, left 1 2 UPDIKE-165 |Side Plate Assembly, 43 |3230-6 Bolt, x 2" Left consisting of carriage 2 side plate & outer 44 PD-302E | Motor Platform 1 ‘Bearing Race 1 45 | D-211 Spacer Tube End 2 3 13253-6 Lack washer, 7/16" Reg.
PARTS LIST Ref. No, Raf. Part No. Description Used No, | Part No. Description Used 107 | BE-137-1 | Pacer, Bracket 1 125 | 3210-15 Screw, x 1-5/8 1 108 | 325-15 Screw, 126 | PD-255 | Upper Handle Says. concoct | 3251-8 Sower, 10-24 x ¥' N.C, 1 siting of upper 110 | 3256-14 Washer #10 1 handle, plug buttons 111 | PD-17 Bracket, Handle Stop 2 & Plastic Grip 1 1121 3210-8 Brew, 5/16" N.F.