Installation Instructions

ManualsBrandsToro ManualsVehiclesBench Seat Base Kit, Workman GTX Series Utility Vehicles

Table Of Contents

FormNo.3412-113RevA

BenchSeatBaseKit

Workman

GTXSeriesUtilityVehicles

ModelNo.07047

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Important:YoumustinstalltheSeatHingeKitbeforeinstallingtheBenchSeatBaseKit.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekeyfromthekeyswitch.

g038447

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3412-113*A

Summary of content (8 pages)

PAGE 1
Form No. 3412-113 Rev A Bench Seat Base Kit Workman® GTX Series Utility Vehicles Model No. 07047 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Important: You must install the Seat Hinge Kit before installing the Bench Seat Base Kit. Preparing the Machine 1. Park the machine on a level surface. 2. Engage the parking brake. 3.
PAGE 2
Installing the Seat Assembly 1x 1x 2x 2x 2x 1. Install the bottom cushion with the brackets into the pins on the seat base, and lower the bottom cushion (Figure 2). 2. Install the back rest frame and cushion assembly to the handholds using the 2 bench seat casting mounts, 2 screws (3/8 x 2-1/4 inches), and 2 locknuts (3/8 inch) as shown in Figure 2.
PAGE 3
Installing the Radio Mount 1x 1. Remove the existing torx-head screw from the dash (Figure 3). Note: Retain the torx-head screw. 2. Install the radio mount to the dash using the previously removed torx-head screw (Figure 3). 3. Torque the torx-head screw to 4.5 to 5 N∙m (40 to 45 in-lb).
PAGE 4
Drilling the Accessory Holes CAUTION When drilling holes into the seat base of the Workman GTX Electric Utility Vehicle, you could accidentally drill into the battery, spraying battery acid or resulting in electrical shock. Be careful to drill into the seat base only. Do not drill into the battery. Drill the accessory holes as shown in Figure 4.
PAGE 5
Mounting the Accessory 1x 1x 4x Install the cup-holder bracket and cup-holder divider bracket into the holes in the seat-base panel using the 4 pop rivets (Figure 5).
PAGE 6
Notes:
PAGE 7
Notes:
PAGE 8