~ Operating& Maintenance Instructions 2068 42 in. (107 om} Side Discharge Mower 600-Series Rio Wheel Horse. MOWGLI‘ Tractors & Riding Mowers PART NUMBER 810731R1 PRINTED IN U.S.A.
MODEL AND SERIAL NUMBER A Model and Serial Number identifies your Toto Whee! Horse attachment, These numbers should always be referred to when consulting with your dealer or factory conceding send, replacement pants, or questions you may have. If Model and Serial number plate Is removed during repair operations & should always be replaced. For your reference, record number from Model snd Serial Number plate on your attachment.
Open right and left Allah-A-Matic hitches {Fig, 3); push release buttons in and lower shandies. Lower height control fever all the way down. Raise left and right front mower attaching arms Into hitches {Fig. 4}, Raise shandies and be sure they lock in raised position. Position drive belt on front pulley. i FlG. 4 Front Attach-A-Masc Hitch Locate two hanger rod assemblies (Fig. 8). Insert mower hanger rads Ina left and right front holes of machine frame. Install spacers annunciations onto with nuts.
position {Fig. 10}, Chandler adjust mower love as necessary. FiG. 18 Belt Tension Handle (Operate Position} MOWER REMOVAL Remove dive belt by reversing procedures under "IN TALL DRIVE BELT” section of this manual. Lower mower all the way down and remove deft and right hanger rod grunions from mower (Fig, 11}, Fig. 11 Errs Dowser Mounting Open left and right front Atlas-A-Matic hitches (Fig. 12). Raise lift lever into middies cutting height.
MOWER DECK SPICULE ) MEASURE MERE ——sirree] 7 1 LEVEL Surf Ace FiG. 14 Mower Lave! Measurement OK HANDIER ROD ADJUSTER) L3k L2l OPERATION IMPORTANT Emery e mower s hassled, sank for proper op Dion of BT0 clutch and brake, Adjustment of PTO fs covered in machine Operator's Mama, Ta mow extra tall grass, raise mower to #ts highest position tor a first cutting and use a slow ground speed. Then re-cut grass 1o normal height.
To obtain optimum mowing results, mower blades should be kept sharp and well balanced. Te sharpen blades, remove mower from machine and invert mower. Remove blades using supplied Wheel Horse spindle blade wrench. Hold spindle shaft hex nut with wrench while removing blade attaching nuts and washers from end of spindles.
A separate parts manual for your Toto Wheel Horse attachment can be obtained by completing the attached form below. You will receive an invoice with manual. PUBLICATIONS TOR WHEEL HORSE 8111 Tyndale Ave. So. Blooming ton, Minnesota 55420 MAIL LABEL PLEASE PRINT CLEARLY PARTS MANUAL ORDER FORM Enter number shown on your attachment: To: Name Address.