Installation Instructions

ManualsBrandsToro ManualsWalk-Behind MowersHandlebar Extension Kit, HoverPro 450/550 Machine

FormNo.3449-865RevA

HandlebarExtensionKit

HoverPro

450/550Machine

ModelNo.02628

InstallationInstructions

Installation

MediaandAdditionalParts

Description

Qty.

Use

Handlebarextension1

Operator-presencecontrolcable

Handwheelknobs2

U-bolt2

Cabletie

Installthehandlebarextensionkit.

Note:Retainallremovedpartsforlaterinstallation

unlessotherwiseindicated.

1.Shutofftheengine,removethekey(if

equipped),waitforallmovementtostop,and

allowthemachinetocool.

2.Removetheoperator-presencecontrolcable

fromthehandlebar(Figure1).

g367354

Figure1

1.Bolt(1/4x1-3/4inches)3.Handlebartting

2.Upperhandlebar

4.Locknut(1/4inch)

3.Disconnecttheremovedcablefromthe

operator-presencebailbracketbyanglingthe

cablettingfree(Figure2).

g367355

Figure2

1.Operator-presencebail

bracket

2.Cabletting

4.Removetheotherendoftheremovedcable

fromtheengine.

Important:Notehowthecableisconnected

totheengine,thenewcableisinstalledin

thesameway.

Note:Youmaydiscardtheremoved

operator-presencecontrolcable.

5.Removethe2handwheelknobs,washers,and

U-boltsthatsecuretheupperhandlebartothe

lowerhandlebar(Figure3).

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUK.

AllRightsReserved

*3449-865*

Summary of content (4 pages)

PAGE 1
Form No. 3449-865 Rev A Handlebar Extension Kit HoverPro® 450/550 Machine Model No. 02628 Installation Instructions Installation Media and Additional Parts Description Use Qty. Handlebar extension Operator-presence control cable Handwheel knobs U-bolt Cable tie 1 1 2 2 3 Install the handlebar extension kit. Note: Retain all removed parts for later installation unless otherwise indicated. 1.
PAGE 2
g364684 Figure 3 1. Lower handlebar 4. Upper handlebar 2. Handwheel knob 3. Washer (6mm) 5. U-bolt g373226 6. Figure 4 Secure the handlebar extension to the lower handlebar using the 2 handwheels and 2 U-bolts provided (Figure 4). 1. Operator-presence control cable 2. Handwheel 4. Handlebar extension 7. Using the 2 handwheels and 2 U-bolts you removed in step 5, secure the upper handlebar to the handlebar extension (Figure 3). 8.
PAGE 3
g018582 Figure 5 1. Flywheel brake lever 3. Brake control cable 2. Bracket 4. Loose cable fitting 11. Using the supplied cable ties, secure the cable to the handlebar upper and lower sections. 12. Operate the machine and ensure that the operator-presence bail shuts off the machine when it is released; refer to the HoverPro Operator’s Manual. Important: When you release the operator-presence bail, both the engine and cutting disc should stop within 3 seconds.
PAGE 4