Installation Instructions

ManualsBrandsToro ManualsWalk-Behind MowersSwing Tip Kit, HoverPro 450 Machine

FormNo.3437-275RevA

SwingTipKit

HoverPro

450Machine

ModelNo.02627

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Disc1

Plasticblade3

Washer3

Shoulderbolt

Allenwrench1

1.Positionthemachineonalevelsurface,shutoff

theengine,andwaitforallmovingpartstostop

beforeleavingtheoperator’sposition.

2.TurnthefuelswitchtotheOFFpositionand

disconnectthespark-plugwirefromthespark

plug;refertoyourmachineOperator’sManual.

3.Tipthemachineontoitssidewiththedipstick

downandremovetheexistingbladeand

hardwarefromthemachine;refertoyour

machineOperator’sManual.

4.Installthedisctothemachineasshownin

Figure1.

Note:Adjustthespacersforthedesiredcutting

height;refertoyourmachineOperator’sManual.

5.Useatorquewrenchtotightentheboltremoved

instep3to25N∙m(18ft-lb).

g309198

Figure1

1.Largespacer4.Retainer

2.Spacers

5.Bolt

3.Disc

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3437-275*A

Summary of content (2 pages)

PAGE 1
Form No. 3437-275 Rev A Swing Tip Kit HoverPro® 450 Machine Model No. 02627 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Disc Plastic blade Washer Shoulder bolt Allen wrench 1 3 3 3 1 1. Position the machine on a level surface, shut off the engine, and wait for all moving parts to stop before leaving the operator’s position. 2.
PAGE 2
6. Install the 3 plastic blades, washers, and shoulder bolts to the disc to as shown in Figure 2 using the provided Allen wrench. g309199 Figure 2 1. Disc installed to the machine. 2. Washer 3. Plastic blade 7. 4. Shoulder bolt 5. Allen wrench Turn the fuel switch to the ON position and connect the spark-plug wire to the spark plug; refer to your machine Operator’s Manual.