User's Manual
Flex Pointer-TS/AQ User Manual
How to use the remote:
1. Plug the receiver unit into any USB port.
1. Your operation system will start to setup the receiver unit. There is no
software to load. (Win98/Me may show some dialog boxes during
setup process. Press “Next” on all dialog boxes and then “finish”.
During setup process, the O/S may ask you to put Win98 CD into the
CD-ROM.)
2. After the setup process finish, the remote will work.
Notice:
1-1. If the remote is not working or interference with another:
ID Change : Press Both “ M “ and “ B ” buttons simultaneously
more than 3 seconds will change the
currend ID . (Green LED flashed)
Pic.1 Pic.2
1-2. Use a paper clip to press the receiver unit red button (Stand by to
learn the new ID)---Pic.2
1-3. Press any button except “M “ button to operate. (Let receiver unit
learn the new ID).
2. If you remove the battery or the remote does not work, repeat the
steps 1-1 to 1-3.
1