User Manual of the Universal Keypad Model: TC188（LM188） NOTE: Please read this manual thoroughly before installation and programming.
NOTE: The keypad is universal for both wireless and wired application. You can try the wired application if the interference affect the remote control range or the wireless code is not matching your gate opener. You must use external wired power source to power up the keypad if you choose the wired application. Specifications Power input: 9VDC carbon battery for wireless application or 9-24VAC/DC for wired application Frequency: 433.
Step 2: Install the baseplate to the wall or the post with the screws included in the kit. Step 3: Install the baseplate back to the back cover of the keypad. Universal Control Board Connection for Wired Application You can connect the 1# and 2# terminals of the keypad to the terminals for push button of the gate opener. No matter the polarity. And then you can connect the 3# and 4# terminals of the keypad to the 9-30VAC/DC auxiliary output terminals of the gate opener. No matter the polarity.
Programming the Keypad NOTE: There are two kinds of codes while programming: Master code and Entry code. The master code is used to program the keypad.The entry code is used to activate the keypad to control the gate opener. You can program the temporary codes and the permanent entry codes according to your needs. The use number of times of the temporary entry codes can be programmed at the same time. NOTE: Max. 32 permanent entry codes and 32 temporary codes can be programmed to the keypad.
board to operate the gate opener. You don’t have to input the entry code again within 3 seconds after the key A or key B is activated. Reset the Master Code of the Keypad There is a reset button on the back of the control panel of the keypad. You can hold and press the button for 4 seconds until the blue backlights flash quickly and the buzzer beeps 2 long sound. The master code has been restored to factory default value: 9999.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
