User's Manual

   NJT528WLAN USER’S MANUAL

Over View

This device is a 802.11g/b WirelessLAN Module.Inter face is SDIO Bus.

Physical Specifications

Table A-1 Physical Specification

 Dimensions W:28mm D:13.5mm H:3.5mm

Weight 1g

Input / output SDIO/Power/antenna

Input voltage 3.3V± 5% /320mA (typ)

Operating temperature -15-+55℃

Strage temperatuere -30-80℃

Wireless specifications

Table A-2 Wireless Specifications

Standard IEEE802.11/b/g

Frequency modulation technique T DS-SS(11b),OFDM(11g)

Data speed T 1,2,5.5,11,6,9,12,18,24,36,48,54Mbps

Frequency Range 2412-2462MHz

Channel 1-11

Output power 15dBm

Installation Guide

1. Module connected to SDIO Port on the mother Board in your Equipment. (see below)

NAME SPEC MODEL

I/F Connecter SDIO Port AXK5F20337YG

RF Connector

Antenna coaxial connector

U.FL-R-SMT

*We are preparing driver software.

Mother Board

SDIO Port

Bottom View

Top View

Connect to SDIOPort

Antenna

PAGE 1
NJT528WLAN USER’S MANUAL Over View This device is a 802.11g/b WirelessLAN Module.Inter face is SDIO Bus. Physical Specifications Table A-1 Physical Specification Dimensions Weight Input / output Input voltage Operating temperature Strage temperatuere W:28mm D:13.5mm H:3.5mm 1g SDIO/Power/antenna 3.3V± 5% /320mA (typ) -15-+55℃ -30-80℃ Wireless specifications Table A-2 Wireless Specifications Standard Frequency modulation technique T Data speed T Frequency Range Channel Output power IEEE802.
PAGE 2
Confirm the homepage of Microsoft to the method of installing the driver software. You must make sure that 20cm minimum separation is maintained between users and the antenna. Warning Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Regulatory Information Compliance statement to FCC/IC This module complies with part 15 of the FCC rules and IC RSS-210.
PAGE 3
The following statement is expressed on the user’s instruction manual. For Class A device; NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.