User's Manual

ManualsBrandsTopcon America ManualsElectronicsRadio Holder

(1/4)

RH-1 USERS MANUAL

Please read these Terms and Conditions carefully.

This product is designed to be used by a professional. The user should have a good knowledge of

the safe of the product and implement the types of safety procedures recommended by the local

government protection agency for both private use and commercial job sites.

Any changes or modifications to the equipment not expressly approved by the party

responsible for compliance could void your authority to operate such equipment.

Turn off the power supply near a highly accurate electronic equipment.

RH-1

・Outline of product

RH-1 is GPS receiver in GRS-1 to measure the GPS data in real time.

RH-1 supplies the electric power to GRS-1 by two battery and outside AC power, and

enables the operation of GRS-1 of long time.

・Physical

Dimensions ： 8.50” x 5.83” x 6.71” ( 216 x 148 x 170.5 mm ) no Antenna

：15.47” x 5.83” x 6.71” ( 393 x 148 x 170.5 mm ) with Antenna

Weight ：1.4Kg

Input / output ：Bluetooth,Serial, Power, Antenna,Communication pins(for GRS-1)

Battery Type ：Li-ion battery, Rechargeable / Replaceable

Input voltage ：12 to 20V

Operating temperature ：-20 C° to +50 C°

Strage temperatuere ：-30 C° to +60 C°

Waterproof ：IPX4

・Use

1. GRS-1 is installed in the holder.

2. Pushing the switch long , that RH-1 LEDs is lit.

3. Pushing the switch short , that RH-1 LED4 is matched to the machine used.

4. The power of GRS-1 is turned on.

The user doesn't operate GPS from RH-1,because The user does all the operations

concerning GPS from GRS-1.

The electric power is supplied to GRS-1 without operating it under such a condition.

Summary of content (4 pages)

PAGE 1
RH-1 USERS MANUAL Please read these Terms and Conditions carefully. This product is designed to be used by a professional. The user should have a good knowledge of the safe of the product and implement the types of safety procedures recommended by the local government protection agency for both private use and commercial job sites. Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void your authority to operate such equipment.
PAGE 2
・LED LED 1: Battery 1 (Red and Green) Green: Using / Battery Full Red Blink: Using / Battery Empty LED 2: Battery 2 (Red and Green) Green: Using / Battery Full Red Blink: Using / Battery Empty LED 3: Radio Modem Status (Green and Orange), Same as GR-3 Radio status LED.
PAGE 3
FCC Regulatory Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications not expressly approved by the party responsible for product compliance could void the user's authority to operate the equipment.
PAGE 4
Industry Canada Canada Regulatory Compliance Statement This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numériqué de la classe B est conformé à la norme NMB-003 du Canada. For Customers in Canada This device complies with RSS 210 of Industry Canada (IC). Operation is subject to the following two conditions: ・this device may not cause interference, and ・this device must accept any interference, including interference that may cause undesired operation of this device.