User Manual

ManualsBrandsTop Victory Electronics ManualsElectronics17" COLOR MONITER

Before operating the monitor please read this manual thoroughly. This manual should be

retained for future reference.

FCC Class B Radio Frequency Interference Statement

WARNING: (FOR FCC CERTIFIED MODELS)

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy, and if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

Notice:

1. The changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

2. Shielded interface cables and A.C. power cord, if any, must be used in order to

comply with the emission limits.

3. The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modification to this equipment. It is the responsibilities of the user to

correct such interference.

Warning:

To prevent fire or shock hazard, do not expose the monitor to rain or moisture.

Dangerously high voltages are present inside the monitor. Do not open the cabinet. Refer

servicing to qualified personnel only.

Contents

Packing list ----------------------------------------------------

Precautions ----------------------------------------------------

Installation Instructions -------------------------------------

Swivel Base -------------------------------------------------

---

Power cord -------------------------------------------------

Video cable -------------------------------------------------

Operating Instructions ---------------------------------------

General Instructions --------------------------------------

Front panel control ----------------------------------------

How to adjust a setting -----------------------------------

Adjusting the picture --------------------------------------

8-9

Features -------------------------------------------------------

---

Green monitor ---------------------------------------------

9-10

Plug and play -----------------------------------------------

Summary of content (8 pages)

PAGE 1
Before operating the monitor please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Frequency Interference Statement WARNING: (FOR FCC CERTIFIED MODELS) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
Technical Support (FAQ) ----------------------------------- 11 Appendix A – Specifications -------------------------------- 12-13 13 Appendix B – Factory Preset Timing Table -------------PACKING LIST The product package should include the following items: 1. Monitor 2. Owner's Manual 3. Power Cord 4.
PAGE 3
PRECAUTIONS l Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. l Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance. Use only a cart or stand recommended by the manufacturer or sold with the monitor. If you mount the monitor on a wall or shelf, use a mounting kit approved by the manufacturer and follow the kit instructions.
PAGE 4
Video cable Connecting the Video Cable: the monitor comes with a built-in video cable. Plug the signal cable′s 15-pin connector into the computer's video port and tighten the two screws on the cable connector.(see figure 2) Caution:Don’t bend the signal cable, otherwise it will break the inner wire. Connecting the Power Cord: Plug the power cord into the monitor's AC power jack. Then plug the power cord into a grounded AC outlet, UL-approved power strip, or the power output socket on your PC.
PAGE 5
4. To keep the monitor looking new, periodically clean it with a soft cloth. Stubborn stains may be removed with a cloth lightly dampened with a mild detergent solution. Never use strong solvents such as thinner, benzene, or abrasive cleaners, since these will damage the cabinet. As a safety precaution, always cut off the monitor before cleaning it. H: 68.8KHz Contrast Front Panel Control • Standby power key : When pressed, the monitor enters the off mode, and the LED turns orange.
PAGE 6
7.10 PIN-BALANCE : Adjust to compensate the pincushion unbalance. 7.11 PARALLELOGRAM : Adjust the picture to be a rectangle. 7.12 ROTATION : Adjust the picture tilt to horizontal position. 7.13 6500°K/9300°K ( COLOR TEMPERATURE ) : The color temperature for 6500°K is x=0.313, y=0.329 and 9300°K is x=0.283, y=0.297. It presents two different color sets on the screen. You can select 9300° K or 6500°K by pressing the Shuttle Knob. 7.
PAGE 7
Plug & Play DDC1/2B Feature Picture is fuzzy This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities. The communication channel is defined in two levels, DDC1 and DDC2B. The DDC1 is a unidirectional data channel from the display to the host that continuously transmits EDID information.
PAGE 8
Factory Preset Timings : User mode Timings : Misconvergence • Center • Corner 0.3mm Max. 0.4mm Max. Switching mode power supply AC 100-240V, 50Hz/60Hz full range Operating Humidity 0°C to 40°C ambient 10% to 85% relative, non-condensing Weight Dimensions • (Monitor&Base) 17.