OPERATING ENVIRONMENTS & NOTES ® When using this device, keep It away from water. ® Uss the device In ventilated environment, keep It away from fire. Interfering sources. @® Don't takes apart the device, Pleas use the standard power supply, high voltage may damage he device.
MICROPHONE OPERATION INSTRUCTION shown In above cultures: (D Display Screen (@ ODOR Switch (3) Tail Tube @SILO Button (5) Battery Compartment @ Install 2°AA batteries before using the wireless microphone and Installing Instruction Is as follows: 1. Take down the tall tube of mic; 2 Install the batteries and tighten tall tube of mic. VE J 11 Note: The positive and negative | 6 | polarity of battery cannot be Lh reversed.
Instruction: 1. Raga button 2) for 2s to tum ht on/off; then the frequency on the screen will be 2. Cross the HI-LO button @, changed.
RECEIVER INSTRUCTION @ Receiving antenna @ Power switch (long press for 2s to tum It convoy) @ Volume adjusting button for microphone A LCD display screen &) Volume adjusting button for microphone B Ei] J ccc
shown In above pictures: DANTE @ BALE @MIX @DIN BALLAD MANTA Forbears using the device, take out the wireless revolver from the package, and connect the following cables: firstly, use the 8.35 audio cable to connect the receiver's MIX port and other audio devices ( speaker, ampler, mixer, elect. Secondly, strict the antenna, and connect the power cable. Thirdly, check If microphone Is connected to the receiver successfully after muting on the device.
RECEIVER DISPLAY SHOWS ® © As shown in above pictures: @ Signal levels of mic A @) Volume levels of mic A @ Signal revenge of mic A @ Current channel of mic A © Current frequency of mic A © Signal levels of mic B @ Volume levels of mic B ® Current channel of mic B @ Signal receiving of mic B A Current frequency of mic B O07 |S
‘When the receiver Is connected to power supply successfully, but the batteries of microphone are not installed, LGD screen wil display as following clotures: ‘When the receiver Is connected to power supply successfully, and the batteries of microphone ara also installed, LOD screen will display as following clotures: sen mn | OBE)
TROUBLESHOOTING Problem Solution No sound ( RF signal bar ls hot displayed) Check If microphones Is muted on; Check if receiving antenna is erected correctly; Ensure there ara no obstacles between microphone and receiver, and their distance is within the max range. No sound (RF signal bar Is Check If the receiver Is set at downplay but A” signal bar | LCR TO pearls Is not displayed) connected correct.