TW3H WATER PUMP FIND THE HOW TO GUIDE ON Operation Manual 3 YEAR Honda Engine on WARRANTY
TABLE OF CONTENTS 1. Safety Information 1.1 Laws Pertaining to Spark Arresters 1.2 Operating Safety 1.3 Safety while using Combustion Engines 1.4 Service Safety 2. Technical Data 2.1 Screed Board Data 2.2 Machine Data 3. Before Starting 3.1 Recommended Fuel 3.2 Starting Checklist 4. Assembly Guide 5. Operation 6. After Each Use 6.1 Clean Up 6.2 Stor age 7. Maintenance 8. Troubleshooting 9. Limited Warranty 10. How to Wet Screed 11. How to Screed Form to Form 12. Operating on Wet Concrete 13.
Register Your Equipment Thank you for purchasing TOMAHAWK equipment! Your product is covered by the TOMAHAWK Warranty policy, but in order to activate your warranty, we need you to register your product. In addition to activating your equipment warranty, product registration will grant you access to important product updates, streamlined customer service and more.
This manual provides information and procedures to safely operate and maintain this equipment. For your own safety and protection from injury, carefully read, understand and observe the safety instructions described in this manual. Keep this manual or a copy of it with the equipment. If you lose this manual or need an additional copy, please contact Tomahawk Power LLC or visit www.tomahawk-power.
CAUTION: Used without the safety alert symbol, CAUTION indicates a potentially hazardous situation which, if not avoided, may result in property damage. 1.1 Laws Pertaining to Spark Arresters Notice: State Health Safety Codes and Public Resources Codes specify that in certain locations spark arresters be used on internal combustion engines that use hydrocarbon fuels. A spark arrester is a device designed to prevent accidental discharge of sparks or flames from the engine exhaust.
1.2.9 ALWAYS operate machine with all safety devices and guards in place and in working order. DO NOT modify or remove safety devices. DO NOT operate machine if any safety devices or guards are missing or inoperative. 1.2.10 ALWAYS read, understand, and follow procedures in Operator's Manual before attempting to operate equipment. 1.
1.4.3 DO NOT test for spark on gasoline-powered engines, if engine is flooded or the smell of gasoline is present. A stray spark could ignite fumes. 1.4.4 DO NOT use gasoline or other types of fuels or flammable solvents to clean parts, especially in enclosed areas. Fumes from fuels and solvents can become explosive. 1.4.5 ALWAYS keep area around muffler free of debris such as leaves, paper, cartons, etc. A hot muffler could ignite them, starting a fire. 1.4.
2.2 Specifications Model TW3H Outlet Diameter 3" X 3" Max Total Head 89ft Suction Head 25ft Max Discharge 340 gal/min Engine Model GX240 Engine Brand Honda Horsepower Run Time 8 3.25 hrs Fuel Tank Capacity 1.5 gal Weight 93 lbs Product Warranty 2 Year Engine Warranty 3 Year 3.
4. Operating Controls 4.1 Operating Controls 4.1.1 The centrifugal pump is operated using the engine operating controls. The engine controls are located at the engine end of the pump frame. 4.1.2 The controls consist of a throttle lever (for speed control), choke lever (for cold weather starting), fuel shutoff lever (to prevent fuel spills), and a recoil starter (to turnover engine by hand). (Refer to Figure-3.) FIGURE-3 4.2.
4.3 Motor Oil Use Honda 4-stroke oil, or use an equivalent high detergent, premium quality motor oil certified to meet or exceed U.S. automobile manufacturer’s requirements for Service Classification SG, SF. Motor oils classified SG, SF will show this designation on the container. SAE 10W/30 is recommended for general, all-temperature use. Other viscosity grades (see Figure-4) may be used when the average temperature in your area is within the indicated range. FIGURE-4 4.
4.5 Check Engine Fuel WARNING • MAKE SURE YOU REVIEW EACH WARNING IN ORDER TO PREVENT FIRE HAZARD. • DO NOT REFILL TANK WHILE ENGINE IS RUNNING OR HOT. • CLOSE FUEL SHUT OFF VALVE BEFORE REFUELING. • BE CAREFUL NOT TO GET DUST, DIRT, WATER OR OTHER FOREIGN OBJECTS INTO FUEL. • WIPE OFF SPILLED FUEL THOROUGHLY BEFORE STARTING ENGINE. • KEEP AWAY FROM OPEN FLAMES. • DO NOT USE SMOKING MATERIALS WHEN FILLING THE FUEL TANK. • DO NOT REFUEL WHILE SMOKING OR NEAR OPEN FLAME OR OTHER SUCH POTENTIAL FIRE HAZARDS.
5.2 Starting and Operating the Engine 5.2.1 Refer to the Honda engine owner’s manual. 5.2.2 Put the fuel valve in the ON position. 5.2.3 Move the choke lever to the closed position. NOTE: • The choke may not be needed if the engine is warm or the air temperature is high. 5.2.4 Set the ON/OFF switch to ON (the ON/OFF switch is mounted on the recoil shroud). 5.2.5 Move the throttle lever slightly to the left. 5.2.6 Pull the starter grip lightly until resistance is felt, then pull briskly.
6.2 Changing Engine Oil 6.2.1 An initial oil change should be performed after the first twenty- (20) hours of use. Thereafter, change oil every 200 hours or as directed on the oil packaging. 6.2.2 Before changing the oil, check for a suitable way to dispose of the used oil. Do not pour it down sewer drains, onto garden soil or into open streams. Refer to your local zoning and environmental regulations for disposal and handling requirements. 6.2.
7. Maintenance To maintain the centrifugal pump in peak operating condition, observe and implement the maintenance and adjustment schedule in the table below. Inspect and/or service the centrifugal pump at the intervals shown below.
8. Troubleshooting The troubleshooting tables below can be used as a guide to isolate centrifugal pump faults. Refer to these tables when the engine fails to start after several attempts. If, after following these procedures, the pump fails to start, contact the nearest Tomahawk pump dealer. Fault Pump does not pump. Discharge flow or pump pressure too low. Pump primes too slowly.
9. Limited Warranty Tomahawk Power LLC. ("We'' or "Us'') warrants to the original purchaser only ("You'' or “Your”) that the Tomahawk product purchased will be free from material defects in both materials and workmanship, normal wear and tear excepted, for a period of 1 year from date of ourchase. The foregoing warranty is valid only if the installation and use of the product is strictly in accordance with product instructions.
Assumption of Risk You acknowledge and agree that any use of the product for any purpose other than the specified use(s) stated in the product instructions is at Your own risk. Governing Law This limited warranty gives You specific legal rights, and You also may have other rights which vary from state to state. Some states do not allow limitations or exclusions on implied warranties or incidental or consequential damages, so the above limitations may not apply to You.
COMPACTION FINISHING GENERATORS 3,550 lbs/ft Vibratory Rammer 3,400 lbs/ft Plate Compactor 3,000 lbs/ft Plate Compactor 3.6 HP Honda GXR120 Engine Easily achieve a 100% compaction rating 3-in-One Fuel System with carburetor protection 13” x 11” plate for narrow trenches and corners 3 Year Engine Warranty & 1 Year Product Warranty 5.5 HP Honda GX160 Engine Easily achieve a 100% compaction rating 22” x 20” cold, rolled steel beveled base plate Includes 3.
USE CODE SAVE10 AT CHECKOUT FOR 10% OFF AND MORE PEST CONTROL WELDING / POWER YOUR NEXT ORDER* INVERTER SERIES INVERTER SERIES 120 Amp Portable Welder Generator 210 Amp Portable Welder Generator 9000 Watt Generators Steady 120 Amp DC welding output 60% Duty Cycle for extended use Suitable for welding rods from 6010 to 6013 Includes wheel kit for job site portability 2 Year Product Warranty Steady 50 - 210 Amp DC welding output 60% Duty Cycle for extended use Suitable for welding rods from 6010
Power Your World Tomahawk understands to keep a job-site running smoothly the proper equipment and spare parts are needed at the drop of a hat. With same day shipping and faster delivery times, count on Tomahawk to keep you powered throughout the day! With long lasting parts and engines, Tomahawk equipment will be the star of your fleet for years to come. Visit www.tomahawk-power.com to get started today! Tomahawk Power, LLC San Diego, CA Sales Support (866) 577-4476 sales@tomahawk-power.