Superb Elimination of Electromagnetic Interference Solemnness's original back-cover press fit processing and zinc die-casting housing, integrated with receptacles,provide complete shielded housing and excellent shielding effect against any radio wave interference. Wide Band Band width is 5~2500MHz which covers all of the IF Band of Satellite.
NOTE ¢ Be careful motto connect this splutter (all ports power passing types) with more than two units between the power supplying unit and reception equipment. # No power passing for 20-30V AC. ® Power passing not possible from IN port to OUT port. e Confused IN and OUT ports. How to Install After connecting with cable, install splutter on wooden wall with the two wood screws attached to the splutter itself.
ll F-type connector F-type Connector Installation F-lye connector, provided as accessory, is for 5C cables. NOTE This splutter is indoor use only. Please refrain from using this splutter outdoors.
Cut off the tip of the center conductor at an angle to prevent incomplete contact. The center conductor is covered with white film, Be sure to remove it for better conductivity. Ge Mounting the plug 1.Pass the ferrule through the cable. 2.Fold back the copper braids. 3.Push the plug in firmly.
Fold back the copper braids. > Aluminum foil Ferrule When aluminum foil comes off Push and turn the plug in the cable gently so that the plug turns the aluminum foil in the same direction iris coiled, and be sure to keep the aluminum foil inside the plug.
In addition, be sure to remove any shreds of aluminum foil. G Pressure bonding of ferrule Press firmly al the foot of the plug so halt it does nol come oul.
Make sure the length of the center conductors 2mm. Excessively long center conductor may damage connector and will cause malfunction Straighten the center conductor A bent center conductor may cause short circuit and malfunction.