INSTALLATION AND OPERATING INSTRUCTIONS ! WARNING: Assembly by an adult. This toy is unsuitable for children under 3 years due to its maximum speed. Executive standard: En71 and En62115 ASTM F963-17 Photos are for reference ONLY.
INSTALLATION INSTRUCTION The illustrations in this instruction are used for easier understanding of the operation method of the product and the product structure. Please note there may be differences between the pictures and the physical item. In order to improve the quality, we may change part of the structure and appearance of the product without an advance notice. ! Please read the instructions carefully before use, it will tell you the right operation method and installation steps .
Pay attention while driving the vehicle, avoid falls or collisions causing injury to the user or third parties. Please check the component parts before using, and make regularly examine the transformers or battery chargers for in the event of any damage on the cord, plug, enclosure and other parts, the vehicle shall not be used until the damage has been repaired, to avoid an accident.
Parts List Specification specification Name Battery NO. QTY Suitable age Steering motor:12V*1 Body size 1210*670*400MM Charger Mainmaterial 2 1 B(Instruction Book) A(Steering Wheel) 37-96 months 40KG Hours of use 1 PICTURE Motor: 12V*2 Maxweight Speed NO. QTY Battery: 12V 4.5AH(6-FM-4.
Installation Steps Rear ② P ① ③ ⑤ ④ ⑤ ④ ③ ① ② ② ① ③ ③ ① ② Front P Step 2: Install the front wheel Use the P (M8 spanner) to loosen the ②(M8 screw) ①(M8 gasket) from the ③(rear axle) in a counterclockwise direction. Step 1: Install the rear wheel 1. Use the P (M8 spanner) to loosen the ②(M8 screw) ①(M8 gasket) and ③ (Circular paper tube) from the ④ (rear axle) in a counterclockwise direction. (pay attention, keep the ⑤ at rear axle, avoid fall off) .
A M S Step 3: Install the steering wheel Step 6: connect the power Connect S, M terminal firstly, then align the correct position and press A (steering wheel) on (steering yoke) as shown in figure. Remove the plastic cover from the red terminal (attention: put it at the safe place where far from the children to prevent the risk of asphyxiation) , Find the positive electrode (the red port showed by arrow in figure), connect power port to the red terminal.
1.All batteries should be inserted in the correct polarity. 2.Non-rechargeable battery cannot be recharged 3.Before charging, the rechargeable battery must be taken out from the toys. 4.Take out and properly deal with the dead battery. To avoid injury, please keep kids away from the battery. 5.The direct contact between the positive and negative terminals may result in fire or explosion. Avoid direct connect between the terminals. 6.Do not mix old and new batteries.
4.Instruction for MP3 multifunction player A 6.The illustration of High/Low Speed B The hi/lo speed switch into the position of “low speed”, step on the foot switch the car will move forward slowly, loosen the pedal the car will stop. Put the hi/lo speed switch into the position of “high speed”, step on the foot switch the car will move forward fast, loosen the pedal the car will stop. USB TF ◀◀/V- ▶▎▎ ◀◀▎/V+ ▎ MODE AUX C D E F G H A.
8.Instructions of the recoverable fuse Resettable fuse: when the current exceeds a certain rating, the recoverable fuse will automatically cut off the power supply for 5-10seconds, then the current will be resupplied. (optional) Trouble elimination methods The motor does not rotate 9.Charging instructions. 1 2 3 5 4 When battery power is low,please charge it immediately. The charging port is under the seat. (Note: toys can not be operated in the charging state.