Motion Detector User and Integration Manual Revision A
Motion Detector User and Integration Manual Copyright © 2019 The Nielsen Company (US), LLC. All rights reserved. Nielsen and the Nielsen Logo are trademarks or registered trademarks of The Nielsen Company (US), LLC. Other company names, products and services may be trademarks or registered trademarks of their respective companies. This documentation contains the intellectual property and proprietary information of The Nielsen Company (US), LLC.
Motion Detector User and Integration Manual Contents 1. Introduction ..................................................................................................................................................................... 4 2. Power Interface ............................................................................................................................................................... 4 3. 4. 5. 6. 2.1. Overview ..........................................................
Motion Detector User and Integration Manual 1. Introduction The motion detector is a combined BLE RF device that can be installed as an RF module ® on a host device. It is comprised of a BLUETOOTH Low Energy transceiver plus an accelerometer. This document describes how the device should be connected when used on a host device. 2. Power Interface 2.1. Overview The module is designed to operate on a DC power supply within 2.7 – 3.6 V. The host must provide safe and continuous power to the module. 2.2.
Motion Detector User and Integration Manual Figure 1: Top View of Circuit Board for Motion Detector Figure 2: Bottom View of Circuit Board for Motion Detector Revision A Page 5 Nielsen Confidential
Motion Detector User and Integration Manual 2.3. Motion Detector Installed on Host Device When the unit is installed on a host device, rather than used as a standalone unit, use the power connections in Table 2 Table 2: Pin Numbers for Installation on Host Device Pin Number 2.4. Pin Name Description 10 VDD_BAT 3.3V DC power supply 4 GND Ground. power supply return Ratings Table 3: Ratings Parameter Typical Supply current 10 Units uA 3. Communication Ports 3.1.
Motion Detector User and Integration Manual 3.2. UART Port The module also contains a UART port to interface with host board. The UART implements support for the following features: • • Full-duplex operation • • Automatic flow control • • Parity checking and generation for the 9th data bit Table 5 shows connections to the UART interface with associated pin numbers. Table 5: Pin Numbers for UART Port Pin Number Pin Name Function 7 UART0_RX RX 8 UART0_TX TX 4. Other Signals 4.1.
Motion Detector User and Integration Manual 5. Antenna This section describes the type of antenna used on the module. 5.1. Antenna Type The module incorporates a board-mounted, ceramic chip antenna (Johanson Technology 2450AT18B100) and associated matching circuit. The host board does not need any antenna-related circuitry. 5.2. Antenna Characteristics Table 8 lists the characteristics of the antenna mounted on the module. Table 8: Antenna Characteristics 6.
Motion Detector User and Integration Manual If the host device is subject to other authorization procedures or parts, the appropriate requirements of these authorization procedures or parts apply. The end device must be labeled with the following statement: Contains FCC ID: 2ASUZ003 (enter FCC ID on the Label) 6.2. Additional Testing The host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
