Instructions / Assembly

Notch
24”
TOOLS & EQUIPMENT NEEDED:
Ladder, Safety Goggles, Gloves, Tin Snips, Cordless Screwdriver,
#8 Hex bit & Bending Tool.
#8 x 1/2” Self-Tapping screws (included)
Only for the 25 pack (model # 8552556036S)
SAFETY:
Use safe ladder equipment and safe ladder practices
Works with any
K-style hangers
STEP-UP PROFILE:
• Ensure gutter system is clean
and free of debris
• Inspect gutter hangers, ensuring:
• tightly fastened to fascia and
attached to gutter
• minimum one hanger every
24 inches
• Before installing the first
TITAN 3000 measure 2 inches
from the end and notch the
front and back of the TITAN
3000 Bend remaining 2 inch
flap 90 degrees to create an
end cap
• Next fasten the back edge of
the TITAN 3000 to the drip
edge/fasica board in line with
the screw in the front edge
• Continue fasten the front and
back of the of the TitanGuard
every 24 inches
• Overlap sections approximately
1 inch and fasten together to
the gutter lip
• For outside and inside corners
mitre cut adjoining section and
notch front edge to create an
overlap
• Fasten the overlapping
sections together with a screw
Note: Inside corners and valleys
will require a splash guard
diverter on top of the TITAN
3000
• Install the first TITAN 3000 at
the beginning of the gutter run
by fastening the front edge to
the gutter lip using the pre-
drilled hole closest to the end
of the TITAN 3000. (Use the 1/2”
screws provided. Do not over
tighten)
1 4
2 5
3 6
INSTALLATION INSTRUCTIONS
amerimax.com | 800.347.2586
GUTTER GUARD
TITAN 3000
®