Installation Guide

ManualsBrandsTile Redi ManualsBathRedi Base 60 in. L x 34 in. W Alcove Single Threshold Shower Pan Base with Left Drain in Brushed Nickel

INSTALLATION INSTRUCTIONS

TOOLS REQUIRED

These instructions are exclusively for Tile Redi (yellow shower pans). If you have received a black

(Redi Your Way®) shower pan please visit tileredi.com/knowledge-center for the correct instructions.

Tile Redi® Shower Pan

Thin-set

Tile

Mortar

Backer board with

Waterproofing

Subfloor

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS These instructions are exclusively for Tile Redi (yellow shower pans). If you have received a black (Redi Your Way®) shower pan please visit tileredi.com/knowledge-center for the correct instructions.
PAGE 2
Ø 6-7” 1. Frame out shower stall area to shower pan dimensions. The bore hole needs to be a minimum 6”, but not more than 7” diameter opening*. Ensure that the shower pan subfloor is level, and that the walls are level, plumb, and square. Place the square in corners to ensure they are square and straight. All walls and framing must be plumb prior to proceeding. The floor must be level within 3/8”. Sweep up any debris from subfloor.
PAGE 3
5. Spread your mortar base (should be a milk shake consistency), evenly across the subfloor at the thickness calculated in Step 4. 6. Offset the mortar base 1“ from each outside edge of the pan with exception of the curb side. Mortar will protrude out from under the curb, run the finishing trowel along curb face to backfill any excess mortar. Mark a line on a shim denoting the distance calculated in Step 4. Use the shim as a depth gauge to verify that the mortar bed is the depth you need. 1” 7.
PAGE 4
10. Install the shower backer board and water proofing in accordance with the standards established by the Tile Council of North America, Inc. Seal and waterproof joint between backer board and the shower pan splash walls using Redi Flash® or 100% silicone. It is recommended to use a membrane and fluid applied waterproof in addition to the Redi Flash® or 100% silicone. Allow the mortar bed to dry in accordance with the instructions of mortar manufacturer. 11.