TigoRFcore User Guide Revision 0.1 Sep. 19, 19 Page 1 of 8 Copyright © 2019 CoreTigo Ltd.
TigoRFcore User Guide Contents Approval Table ................................................................................................................................................................................................. 2 Revision Control .............................................................................................................................................................................................. 3 1 Overview ...............................................
TigoRFcore User Guide Revision Control Author Name Description Revision Date Yaniv Yardeni Creation 0.1 09/09/19 Table 2: Revision Control Page 3 of 8 CONFIDENTIAL Copyright © 2019 CoreTigo Ltd.
TigoRFcore User Guide 1 Overview TigoRFcore Module is a complete physical layer solution for IO-Link Wireless. The module enables a compact, robust and efficient solution for Industry 4.0 applications such as IO-Link Wireless. Figure 1: TigoRFcore 2 Specification Radio: • Output power: 10dBm • Frequency band: 2.4-2.48GHz • Channel BW: 1MHz • Modulation: GFSK Electrical: • Input power: 3.3V D, 1.8V DC Physical: • Footprint: 33 Terminals, 0.8mm Pitch, 7 × 7 × 1.4 [mm] • Wight: 0.
TigoRFcore User Guide 3 Application and Implementation 3.1 Power source DC power of 3.3V and 1.8V should be supplied to the power input ports: Supply 1.8V DC to Pin number 18 – VDD_IO Supply 3.3V DC to Pin number 12 – VBAT 3.2 External clock Slow clock of 32.768kHz should be provided for module startup. Supply slow clock to pin number 8 - SLOW_CLK_IN 3.3 Reset For resetting the module apply GND to pin number 16 – nSHUTD, for releasing reset apply 1.8V DC 3.
TigoRFcore User Guide 3.5 UART External patches can be downloaded from the host to the module through the UART interface. UART interface support adjustable baud rates between 9600bps to 4Mbps UART configuration: Pin 1 - UART_CTS Pin 2 - UART_TX Pin 3 - UART_RX Pin 4 - UART_RTS Figure 2: UART Interface 3.7 RF port RF port is used to connect the module to the antenna. This port should be matched to 50ohm for best RF performance RF port – pin 14 Page 6 of 8 CONFIDENTIAL Copyright © 2019 CoreTigo Ltd.
TigoRFcore User Guide 4 Certification and Regulation FCC ID: 2ATSM-TGRFCM1 4.1 RF Exposure Warnings RF Exposure Warnings This device is only authorized for use in a mobile application. At least 20 cm of separation distance between the TigoRFcore module and the user’s body must always be maintained . 4.2 Class A Warnings The FCC Wants You to Know This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.
TigoRFcore User Guide 4.5 Limited Modular Approval The requirement for KDB 996369 D03: List of applicable FCC rules FCC CFR Title 47 Part 15 Subpart C Section 15.247 Summarize the specific operational use conditions This module has been granted Limited Modular Approval for mobile applications. OEM integrators for host products may use the module in their final products without additional FCC certifications if they meet the following conditions. Otherwise, additional FCC approvals must be obtained.
