COMMAND SERIES 410-L06 | 410-T09 | 420-L06 | 420-T06 | 420-T09 | 420-T15 420-L06R | 420-T09R PRODUCT MANUAL
TABLE OF CONTENTS INTRODUCTION Command Reference Guide 3 Physical Characteristics & Warnings 4 BATTERY Battery Installation 5 Reassembling the Battery Pack 5 COMMAND RECHARGEABLE Charging the Battery Pack 6 Battery Life 6 OPERATION Operational Modes 7 Battery Life 7 INSTALLING STRAPS Elastic Strap 8 Silicone Strap 9 WARRANTY CONTACT FOXFURY 10–11 11
COMMAND REFERENCE GUIDE COMMAND & COMMAND+ TILT LIGHT HEAD TILT PLATE FOAM PADDING POWER/MODE SWITCH LED BUCKLE SLOT (3 EACH) LENS COMMAND & COMMAND+ LO•PRO LIGHT HEAD TILT PLATE POWER/MODE SWITCH BUCKLE SLOT (2 EACH) LED LENS COMMAND & COMMAND+ BATTERY PACK BUCKLE SLOT (3 EACH) REAR FLASHING LED BATTERY PACK TABS (6 EACH) BATTERY PACK COVER 3
PHYSICAL CHARACTERISTICS Please read below before using your Command headlamp as it relays beneficial operating and safety information. P/N NAME WEIGHT DIMENSIONS (L x W x H) 410-L06 Command LoPro (White) 5.3 x 0.7 x 1.0 in (135 x 18 x 25 mm) 410-T09 Command Tilt (White) 4.8 x 1.0 x 1.0 in (122 x 25 x 25 mm) 420-L06 Command+ LoPro (White & Green) 420-T06 Command+ Tilt (White & Green) 420-T09 Command+ Tilt (White) 420-T15 Command+ Tilt (White & Amber) 6.4 oz (181 g) Without Battery 9.
BATTERY The Command Series requires four (4) AA batteries. Acceptable battery types include: Alkaline or rechargeable Alkaline, rechargeable NiMH or LiFeS2 (all are 1.2 to 1.6 volts each). Do not leave batteries in the Battery Pack for periods longer than three (3) months without use. Be sure to check the Battery Pack every month for battery corrosion. NOTE: Corrosion from leaking batteries is NOT covered by the warranty.
COMMAND RECHARGEABLE CHARGING THE BATTERY PACK (FOR P/N 420-L06R, -T09R ONLY) 1 Begin by plugging the AC-DC Adaptor into an outlet. The Charge Indicator will then turn solid green. 1 1. Plug the Barrel Connector into the Battery Pack. Once plugged in, the Charge Indicator on the AC-DC Adaptor, will turn solid red to indicate that it is charging. Once fully charged, the Charge Indicator (located on the AC-DC Adaptor) will change back to solid green. Charging time will be approximately 3.5 hours.
COMMAND+ TILT, COMMAND+ LO•PRO, RECHARGEABLE: ON/LOW mode: Press the Power/Mode Switch once. The center 4 LEDs will turn on. MEDIUM mode: From LOW mode, press the Power/Mode Switch once. The center 12 LEDs will turn on. HIGH mode: From MEDIUM mode, press the Power/Mode Switch once. All 20 LEDs will turn on. NOTE: All P/Ns listed above will power OFF after HIGH mode. When ON (for all modes), the rear LED (located on Battery Pack) will flash.
INSTALLING THE ELASTIC STRAP | 5 MINS (APPROX) (WATCH THE VIDEO: FOXFURY.COM/VIDEOS) 1 2 3 FoxFury logo on strap should face inward for STEP 1 4 Place the headlamp on a flat surface. Position the Light Head so the Power/ Mode Switch is on the left and the LEDs face forward. NOTE: Make sure the FoxFury logo on the Battery Pack is correctly oriented before beginning. 8 1 1. Begin with the end of the strap that does not have the Buckle attached.
INSTALLING THE SILICONE STRAP | 5 MINS (APPROX) (WATCH THE VIDEO: FOXFURY.COM/VIDEOS) 1 2 3 4 Place the headlamp on a flat surface. Position the Light Head so the Power/ Mode Switch is on the left and the LEDs face forward. NOTE: Make sure the FoxFury logo on the Battery Pack is correctly oriented before beginning. 1 1. The Silicone Strap comes with two (2) buckles. Attach the first buckle onto one end of the strap (about six (6) inches from the end).
WARRANTY AND OTHER INFORMATION PRODUCT DURABILITY 3M 3M IPX7 Meets NFPA 1971-2007 Fire Resistant Requirements: 500°F (260°C) for 30 minutes. CARE/CLEANING Your FoxFury product is a professional tool, but regular maintenance and care of your light will maximize performance for you. As needed, wash your FoxFury product using a soft washcloth, clean water and a mild soap. Be sure that both the Light Bar and Battery Pack are reassembled securely before washing. When done, pat dry with a damp cloth.
other than FoxFury) prior to your purchase, you are not the Original Purchaser and the product that you purchased is not covered by this warranty. This limited warranty is VOID if this Product has been altered or modified in any way (including but not limited to attempted warranty repair without authorization from Foxfury and/or alteration/removal of the serial number). To expedite warranty concerns, we encourage the end user to register their FoxFury Product at www.foxfury.com/pages/ warranty-registration.
FOXFURY.