Please read this user manual carefully before installation. JTW-ZOM-TC5402W Wireless Addressable Heat Detector User Manual Liaoning·Tiancheng Fire Protection Equipment Co.
Version Date Author Note Ver1.1 Oct. 13, 2020 Zhao Jia; Wang Gang 1st version Yingkou Tiancheng Fire Protection Equipment Co.
I. General JTW-ZOM-TC5402W wireless addressable heat detector (hereinafter referred to as the detector) is a smart home fire detector that uses a high-precision thermistor as the sensor. It can be used with the company’s wireless fire alarm control panel /wireless fire linkage control panel (hereinafter referred to as the device) for supporting use. The detector utilizes advanced wireless transceiver technology and a highly integrated micro-processing chip to process data.
II. Features 1. Using advanced wireless transceiver technology, signal transmission can be completed without wiring, and the project is simple and convenient. 2. Using 470MHz frequency band communication, FSK coding technology, strong anti-interference ability, long transmission distance; 3. With battery low-voltage detection, remind users to replace when the battery is insufficient to maintain the detector's normal operation. 4.
14. Material and color: ABS, off-white 15. Weight: about 110g (including battery) 16. Installation hole distance: 60mm 17. Executive standard: GB 4716-2005 "Point Type Temperature Sensing Fire Detector" XF 1151-2014 "General Requirements for Wireless Communication Function of Fire Alarm System" Yingkou Tiancheng Fire Protection Equipment Co.
IV. Structure and Working Principle 1. The outline diagram of the detector is shown in Figure 1. 10 0 54 Fig.1 Outline diagram of the detector 2. Working principle The detector uses a high-precision thermistor sensor, and the output signal of the sensor is input to the single-chip microcomputer after voltage conversion, and the single-chip uses an intelligent algorithm for signal processing.
The schematic diagram of the base of the detector is shown in Figure 3. Fix the base with two self-tapping screws or stick it firmly with 3M glue. After the base is firmly installed, align the bottom of the detector and rotate the base clockwise to install the detector on the base. Fig.3 Schematic diagram of the base of the detector Yingkou Tiancheng Fire Protection Equipment Co.
1. Points for on-site installation The wireless performance indicators of this product will vary according to the actual use environment. The construction personnel should strictly follow the communication requirements of the wireless product and set the working network segment of the wireless fire alarm system in accordance with the actual working environment of the installation site. VI. Test Warning: Please make sure that the polarity of the battery is correct before proceeding. 1.
4. Device reset: When the device reports a fire alarm and the control panel responds, it can be reset by operating the control panel . After the detector receives the reset signal, it will perform the reset operation. 5. Restore factory settings: After the detector is connected to the network, when it is powered on again, the red indicators will be on for 10s; during this period, the factory settings can be restored by pressing the button five times.
2. Warranty: Our company is responsible for the maintenance of this product. If you find any problems, please contact our company's technical service department in time. Users are not allowed to disassemble or repair by themselves, otherwise the consequences will be at their own risk. 3. The maintenance contact information is as follows: Liaoning·Yingkou Tiancheng Fire Equipment Co., Ltd. Address: No.