TS6 2.4GHz 6CH Radio Control System Instruction manual No.
■ Safety Power Cut-Off protecting function Introduction Congratulations on your purchase of the Innovator TS6+ advanced 6 To prevent accidental shutting-off the transmitter, a unique feature guarantees the transmitter can not be turned off while the helicopter power is on. ■ Auto Cut-off Function In the event the transmitter power is let on after flight, the transmitter will automatically cut-off power after a pre-set period of time to save battery power.
1. Right Stick:Throttle/Aileron control for Mode1 type. Elevator/Aileron control for Mode 2 type. 2. Left Stick: Elevator/Rudder control for Mode1 type. Throttle/Rudder control for Mode 2 type. 3~6. Channel Trim TAB: Trim tabs to trim controls to neutral position on each channel servo. 7. Power Switch Button: Turn the transmitter on or off. 8. Antenna: Bend the antenna up during flight. 9. Voltage Indicator: LED indicates the condition of the transmitter battery.
Installation CAUTION: a) Do not attempt to charge alkaline batteries, they may explode!! b) When charging rechargeable batteries, turn off the power switch before Transmitter batteries replacement/installation: 1) Slide the battery cover in the direction as shown to remove the cover. 2) Install 8pcs alkaline or rechargeable “AA” size cells into the battery charging. The charger plug must be of the correct type (“+” inside and “-“ outside, type TAMIYA N-3U or equivalent).
1.2“Power Off Protection” function Before operating the radio control model, always turn on first the transmitter, then power on the model. After flight, always turn off the model power first, followed by the transmitter. A built-in protecting function in the Innovator TS6 prevents you from accidentally turning off the transmitter while the model / helicopter power is still on. 3.Fly Mode Control Switch 2 types of flying mode can be set up with different flying parameters on the Innovator control unit.
.Binding Process A binding feature is included in the Innovator 2.4 GHz spread spectrum system to ensure the transmitter and receiver bind properly and prevent interference from other controllers. With the Super Combo package, full binding procedure has been completed at the factory prior to shipping. To manually bind Tx/Rx, please proceed as per the following steps: 7.Range-Check A built-in range-check function on the transmitter reduces signal strength for pre-flight.
9.Training Course Use a suitable “buddy” cable to plug into the transmitter mini USB port and connect 2 transmitters (instructor and trainer) for flying lessons. The instructor can give full control to the trainer by holding down the “Trainer” button located on the top-left side of the transmitter. When released, full control is instantly returned to the Instructor.
Accessories AC2262 2.4G TX ANTENNA, TS6 Service AC2266 2.4G RX ANTENNA, TS6 Thank you for purchasing the Innovator TS6 Radio This radio was produced by Thunder Tiger Corp., a guarantee for high quality, services, and hours of trouble free operation from our R/C products. Innovator is sold worldwide through authorized distributors supported directly by Thunder Tiger. To receive the latest product information ref.
8
Exclusive for the INNOVATOR R/C Helicopter www.innovator-rc.com Manufacture by THUNDER TIGER CORP. www.thundertiger.