Specifications

NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communication. However, there is no
guarantee that interference will not occur In a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different fromthat of which the receiver
is connected
- Consult the dealer or an experienced radio/TV technician for help
Head Office - Thumbs Up (UK) Ltd,
Unit L, Braintree Industrial Estate, Ruislip, Middlesex, HA4 0EJ, UK.
T: 0845 466 8880. [e-mail]. www.thumbsupuk.com.
Germany - Thumbs Up GmBh, Rudolf-Diesel-Str.14, D-53859 Niederkassel.
T: [phone]. [e-mail]. www.thumbsup.de
USA - Thumbs Up USA, Unit L, Braintree Industrial Estate, Ruislip, Middlesex, HA4
0EJ, UK. T: 0845 466 8880. [e-mail]. www.thumbsupusa.com
Brought to you by Thumbs Up.
Ruislip, HA4 0EJ, UK
© www.thumbsupuk.com
iPhone®, iPod® & iPad® are registered
trademarks of Apple® Computer Inc. The product
is not licensed, designed, sponsored, endorsed or
manufactured by Apple® Computer Inc.
E&OE images and illustrations may differ
from actual product. iPhone® is not included.
Manniska is a trademark of Thumbs Up (UK)
Ltd. All rights reserved.
MN-WIRLESPB
MADE IN CHINA | FABRIQUÉ EN CHINE
instructions
Wireless SUCTION
powerbank
Controls (diagram)
A. USB charging LED power indicator
B. Wireless charging LED power indicator light (ON/Connected)
C. Wireless charging zone
D. Power ON/OFF button
E. USB output port
F. Type-C input/output
Two charging modes:
Wired charging: Smartphone is charged by powerbank through connecting with a USB cable.
Wireless charging: Smartphone is charged by placing it into the wireless charging zone of the
powerbank and the powerbank must be connected to adapter via a USB cable.
The powerbank can not transmit any wireless signal and energy without connecting to adapter.
Specifications
Capacity
Battery Type
USB Output
Type-C Input/Output
Wireless Charging Output
Recharging Time
5000 mAh
Lithium Polymer
5V/2.4A
5W
3 - 4 Hours
5V/2.4A
Caution
Do not attempt to repair or disassemble the wireless
charger. Any signs of wear and tear please discard
immediately. Do not use if connections are loose. Do not use
your wireless charger in humid, dusty or high temperature
environments. Do not place your wireless charger near
magnets. Wipe clean with a damp cloth only. Do not use
detergents.
Note:
- If the device doesn't charge using the wireless method, make sure it supports
wireless charging and adjust the position on the wireless charging zone.
- If the device won’t switch on, try charging it as it might have a low battery.
- Please disconnect your device from the powerbank when it is fully charged.
- All Led indicators will flash when the powerbank is fully charged. Disconnect the
powerbank from your charging source when fully charged.
Charging the Powerbank
• Insert a Type-C cable into the powerbank and connect to a power source.
• The LED indicators (A) will flash on to confirm that the powerbank is charging.
• When the powerbank is fully charged all the LED lights will be on.
Wireless Charging for Smartphones
1. Switch on the powerbank using the power button (D). The red and green LED
power indicator light (B) will flash. Place your QI/wireless charging compatible device
on the wireless charging zone (C).
2. The green LED indicator light (B) will start shining green and your phone will start
charging to confirm it’s connected.
Charging Devices by Cable
1. Plug the provided charging cable (or your own compatible cable) into the power
bank.
2. The LED power indicators (A) will come on to confirm that your device is charging.
A
B
C
D
E
F
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF exposure warning :
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment shall be installed and
operated with minimum distance 20cm between the radiator & body.
FCC ID: 2AHHEMNWIRLESPB
Product Title1.
2.
3.
4.
RoladeFree
General Text Helvetica
TU Details Helvetica
Warnings Helvetica
Sub Title
Din pro
5.
23/04/2019 CHRISTY CHAN
W 95mm x H 170mm (folded)
80gsm
UNCOATED
EAN 13, 80%
BLACK AND WHITE, DOUBLE SIDED PRINT
FOLDED
Wireless Suction Powerbank
PRODUCT PACKAGING
MANUAL STICKER
MN-WIRLESPB
5060613314647
Opensize: W 380mm x H 170mm