User Guide

ManualsBrandsThomson ManualsOtherGRUNDIG ESP2000

Functions

- Normal Time with PM Indicator

- 12/24 hour selectable

- Dual Alarm, Snooze, Sleep Timer Green LED Backlight display

- Month and Date Display

- Thermometer (32oF - 122-F)

- AM/FM Radio Receiver

Control Location

1. OCEAN button 11. 1-5/1-7/SLEEP button

2. RAIN button

12. ALARM / button

3. STREAM button 13. SET button

4. HEART BEAT button 14. ON/OFF button

5. WOODLANDS button 15. Volume knob

6. Radio/Sound/Beep function slide switch 16. Tuning knob

7. DIAL scale 17. FM/AM slide switch

8. SNOOZE button 18. DC jack

9. MODE button 19. Battery compartment

10. ALARM / button

20. LCD display

Replacing Battery

When the low battery symbol shows on the LCD display (20), open the Battery door (19)

at the bottom, replace the exhausted batteries with three new alkaline "AA" batteries.

Summary of content (5 pages)

PAGE 1
Functions - Normal Time with PM Indicator - 12/24 hour selectable - Dual Alarm, Snooze, Sleep Timer Green LED Backlight display - Month and Date Display - Thermometer (32oF - 122-F) - AM/FM Radio Receiver Control Location 1. OCEAN button 11. 1-5/1-7/SLEEP button 2. RAIN button 12. ALARM 3. STREAM button 13. SET button 4. HEART BEAT button 14. ON/OFF button 5. WOODLANDS button 15. Volume knob 6. Radio/Sound/Beep function slide switch 16. Tuning knob 7. DIAL scale 17. FM/AM slide switch 8.
PAGE 2
Note: If theAC/DC adapter is connected to the DC jack, the batteries are used to maintain clock function only. The batteries can operate the unit with full functions for only a few hours. The unit should be operated with the included adapter. Setting Normal Time When power is on, the clock starts to enter the radio controlled clock mode. The LCD display (20) initially shows: - L: 0-5 receiving signal strength, 5 indicates signal level OK, 0-4 signal weak.
PAGE 3
- Press MODE button (9) once to flash the alarm minute digits, then press UP (10) or DOWN (12) button to set alarm l minutes. - Press MODE button (9) once again to finish alarm l setting (all digits steady) or press SET button (13) to continue alarm2 time setting. To set alarm2 time: -Hold SET button (1 3) for two seconds to enter set mode, press SET button (13) three times to show the symbol and flash the alarm hour digits, then press UP (10) or DOWN (12) button to set alarm2 hour.
PAGE 4
stop automatically) to stop radio or alarm temporarily and give you extra eight minutes of sleep. Within this period, the symbol 'SNOOZE, shows on the LCD display (20). After eight minutes, radio or alarm will come on again. It will repeat if you press the SNOOZE button (8) again within two minutes. To stop the radio or alarm: To stop it, press any control button once except for SNOOZE button, or just wait for two minutes (the alarm will stop automatically).
PAGE 5
Select the sound by pressing the corresponding key. The ON/OFF button and the corresponding key will light up. Important Note This clock is designed as a consumer use item, NOT as scientific equipment. The success of time reception is not guaranteed; it is subject to environmental conditions and the distance from the signal source. This clock is designed for indoor use only. Please avoid high humidity, high temperature, vibration and shock.