User Manual

INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL

The following information (in blue) must be included in the end product user’s manual to

ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must

be included in the manual if the device label is not readily accessible to the end user. The

compliance paragraphs below must be included in the user's manual.

******************************************************************************

FCC ID: DE4-3301TB IC: 2998A-3301T

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt

RSS standard(s). Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

(1) l'appareil ne doit pas produire de brouillage, et

(2) (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si

le brouillage est susceptible d'en compromettre le fonctionnement.

WARNING: Changes or modifications not expressively approved by the party responsible for

compliance could void the user's authority to operate the equipment. The term “IC:” before the

radio certification number only signifies that Industry Canada technical specifications were met.

******************************************************************************

PAGE 1
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL The following information (in blue) must be included in the end product user’s manual to ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must be included in the manual if the device label is not readily accessible to the end user. The compliance paragraphs below must be included in the user's manual.
PAGE 2
INSTRUCTION GUIDE Wireless Chime Buttons RC3302, RC3303, RC4121 Congratulations on a wise purchase! ENCLOSED YOU WILL FIND: • Chime Button • One 3-volt lithium battery (installed) for RC3302 and RC3303 • Two 3-volt lithium batteries (installed) for RC4121 • Double-sided tape • Screws TOOLS NEEDED: • Small Phillips head screwdriver • Medium flat head screwdriver • Ballpoint pen • Drill, if mounting with screws Note: Your new wireless chime button can only be used to add a button to an existing Carlon Wireles
PAGE 3
PROBLEM: Chime only plays “dong.” SUGGESTION: Press Scroll Button on Transmitter to change sound options. another wire. DON’T FORGET THAT EVERY TIME A WIRE IS CUT IN THE CHIME RECEIVER, THE CORRESPONDING WIRE MUST BE CUT IN THE CHIME BUTTON. PROBLEM: Receiver sometimes plays without anyone pressing Chime Button. SUGGESTION: If another Wireless Chime System is on the same frequency nearby, it could accidentally trigger your system. If this happens, change privacy code.